BN Thermic SystemX XAH-180 Instructions

Thank you for purchasing a BN Thermic product. Manufactured to a high standard, this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance. Please ensure instructions remain with your
customer for their reference.
REGISTER: PLEASE REGISTER THIS PRODUCT ONLINE TO ACTIVATE YOUR GUARANTEE AT
PLEASE READ THESE INSTRUCTIONS, NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS,
AND CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
1 . SA FET Y IN ST RUCT ION S
ELECTRICAL SAFETY
1.1
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the
installation of appropriate safety devices. If in any doubt consult a qualified electrician.
You must also read and understand the following instructions concerning electrical safety.
▪
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those
appliances and the safety of the appliance operators. If in any doubt about electrical safety, contact a qualified electrician.
▪
Installation should in accordance with current IEE electrical regulations.
▪
Ensure that the insulation of all the cables on the appliance is undamaged and safe, before connecting it to the power
supply.
▪
Ensure that the cables are always protected against short circuit and overload.
▪
Regularly inspect the power supply cables etc. for wear or damage and check all connections to ensure that none are loose.
▪
Important: Ensure that the voltage marked on the appliance matches the power supply to be used and that a correctly rated
fuse is fitted.
▪
DO NOT use worn or damaged cables or connectors. Immediately have any faulty item repaired or replaced by a qualified
electrician.
▪
A suitable local isolating switch must be provided in the electrical supply circuit as close as possible to the air curtain with at
least 3mm clearance on each pole.
▪
This air curtain is IP20 rated and is suitable for indoor or under cover use only.
▪
Do not attach this air curtain to an extension cord it must always be hard wired in position.
1.2 GENERAL SAFETY INSTRUCTIONS
✓
Remove all packaging and store it away from children, check the package and air curtain for visible damage or tampering.
✓
Familiarise yourself with the applications and limitations of the air curtain.
✓
Ensure the air curtain is in good order and condition both physically and electrically before use. If in any doubt, do not use
the unit and contact your supplier.
✓
Only use recommended attachments and parts. To use unauthorised parts may be dangerous and will invalidate your
warranty.
✓
Keep tools and other items away from the air curtain when it is in use.
✓
Keep children and unauthorised persons away from the air curtain, as it gets hot.
✓
Disconnect from mains and allow to cool before attempting any cleaning or maintenance.
X DO NOT use in areas where hazardous gases or dusts that may be present.
X DO NOT locate the air curtain directly below the power outlet.
X DO NOT disassemble the air curtain for any reason. This air curtain must be checked by qualified personnel only.
X DO NOT use this air curtain to perform a task for which it has not been designed.
❑
WARNING! This air curtain is not equipped with a built in device to control the room temperature. Do not use this air curtain
in a small room if it is occupied by people not capable of leaving the room on their own, unless constant supervision is
provided.
❑
WARNING! Ensure you observe the safety distances and mounting heights and there is no possibility of inflammable
materials coming into contact.
COMMERCIAL AIR CURTAIN
Model:- XAH-180
www. .co.uk
bnthermic
INSTRUCTIONS FOR:-