Table of Contents
Advertisement
Microfilter/activated-charcoal filter
The microfilter removes dust and pollen from
the incoming air. The activated-charcoal filter
provides additional protection by filtering gas-
eous pollutants from the outside air. Your BMW
center replaces this combined filter as a stan-
dard part of your scheduled maintenance.
You can select a display of more detailed infor-
mation on the Control Display, refer to page 66.
Independent ventilation*
The independent ventilation blows air into the
passenger compartment to lower interior tem-
peratures.
The independent ventilation is controlled using
the Control Center. You can set two different
times for the system to start.
The independent ventilation remains on for
30 minutes. It can also be switched on and off
directly. Since the system uses a substantial
amount of electrical current, you should refrain
from activating it twice in succession without
allowing the battery to be recharged in normal
operation between use.
The independent ventilation is ready for use at
any outside temperature, up to ignition key
position 1.
The air emerges through the upper body region
vent outlets in the instrument panel. These vent
outlets must be open for the system to operate.
Switching on and off directly
Control Center, for principle details, refer to
page 16.
1.
Open "Climate".
2.
Select "Parked car operation" and press the
controller.
3.
Select "Automatic ventilation" and press
the controller.
94
Online Edition for Part-No. 01 41 0 158 518 - © 09/04 BMW AG
4.
Select "Parked car ventilation" and press
the controller.
Independent ventilation is switched on and the
LED
flashes.
Preselecting activation times
Control Center, for principle details, refer to
page 16.
1.
Open "Climate".
2.
Select "Parked car operation" and press the
controller.
3.
Select "Activation time" and press the con-
troller.
If you select two activation times that are
in sequence, they must differ by at least
31
minutes.<
4.
Move the controller to the left or right to
select "Time 1" or "Time 2".
5.
Select the time and press the controller.
The first time setting is highlighted.
6.
Turn the controller to make the adjustment.
7.
Press the controller to apply the setting.
The next setting is highlighted.
8.
Make the remaining adjustments. After the
last adjustment, the time is stored.
Advertisement
Chapters
Table of Contents
