BMW SERIE 5 SPORT WAGON 2005 Owner's Manual page 187

With run-flat tires, no tools are provided
for wheel changes. They can be pur-
chased as accessories at your BMW
Compact wheel*
1. Unscrew the wing nut 1.
Remove the washer 2 laterally.
2.
3. Take out the tool mounts 3.
4. Remove the compact wheel.
Preparing wheel change
1. Observe the safety precautions above.
2. Prevent the vehicle from rolling:
Place the chock behind the front wheel on
the other side of the vehicle, or on inclines,
in front of this wheel. On a steep grade, take
other steps to prevent the vehicle from roll-
ing.
3. Loosen the lug bolts a half turn.
Jacking up vehicle
1. Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal
186
Online Edition for Part-No. 01 41 0 158 518 - © 09/04 BMW AG
2. Guide the jack head into the rectangular
recess of the jacking point when cranking
center.< up, refer to illustration detail.
3. Jack the vehicle up until the wheel you are
changing is raised from the ground.
Mounting a wheel
1. Unscrew the lug bolts and remove the
wheel.
2. Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Also clean the lug bolts.
3. Position the new wheel or compact wheel.
Secure the wheel by turning at least two lug
bolts into opposite bolt holes.
When you mount wheels other than Genu-
ine BMW light-alloy wheels, different lug
bolts may also be required.
4. Screw in the remaining lug bolts. Tighten all
the bolts securely in a diagonal pattern.
5. Lower the vehicle and remove the jack from
beneath the vehicle.
After mounting
1. Tighten the lug bolts in a diagonal pattern.
torque wrench as soon as possible to
ensure that they are tightened to the speci-
fied torque. The tightening torque is
injury.<
88.5 lb ft/120
2. When stowing the wheel and tools in the
vehicle, execute these steps in the reverse
order.
To ensure safety, always have the
lug bolts checked with a calibrated
Nm.<