Wiper System; Turn Signals; Headlamp Flasher - BMW SERIE 3 SEDAN 2005 Owner's Manual

To use the automatic function again, move the
selector lever to the right into position D.
Overriding selector lever lock
You can manually override the selector lever
lock in case a defect occurs in which the selec-
tor lever remains in position P although the but-
ton on the selector lever is pressed:
1. Unclip the sleeve of the selector lever.
2. Pull the sleeve up over the selector lever
until the sleeve is inside out.
3. Using the screwdriver from the onboard
tool kit, refer to page 115, hold down the red
lever and move the selector lever to the
desired position in the usual way.

Turn signals/

headlamp flasher

1 High beams
2 Headlamp flasher
3 Turn signals
Using turn signals
Press the lever beyond the resistance point.
Online Edition for Part-No. 01 41 0 159 256 - © 03/05 BMW AG
To turn off manually, press the lever to the
resistance point.
Unusually rapid flashing of the indicator
lamp indicates that a turn signal bulb
needs to be replaced.
After switching off the ignition, make sure that
the roadside parking lamps are not switched
on.<
Signaling for a short time
Press the lever as far as the resistance point.
The turn signals flash three times.

Wiper system

1 Switching on wipers
2
Switching off wipers or brief wipe
3 Activating/deactivating intermittent wipe or
*
rain sensor
4 Cleaning windshield and headlamps
5 Setting speed for intermittent wipe, or sen-
sitivity of the rain sensor
Switching on wipers
The lever automatically returns to its initial posi-
tion when released.
Normal wiper speed
Press once.
The system switches to operation in the inter-
mittent mode when the vehicle is stationary.
Fast wiper speed
Press twice or press beyond the resistance
point.
*
41