Catnets Catio Instructions

47" Cat Catio Tunnel
Instructions
Part List
4x Type A Poles
4x Type B Poles
8x Type C Poles
8x 3-Way Connectors
1x Tunnel Floor
1x Tunnel Netting
75x 150mm Cable Ties
25x 200mm Cable Ties
Preparation & Setup
Check that you have all the required parts.
Make sure to lock in all connectors securely.
Make sure to install the Tunnel on a level
ground surface.
When securing the net, ensure to leave no
gaps by installing a cable tie every 2-3 mesh
squares.
Trim the ends of the cable ties, making sure
to face the trimmed ends of the cable ties
outwards of the tunnel.
Locate and connect the Type A Pole to the Type B Pole
1
to form a large pole.
NOTE: Be sure to align the pin lock with the hole
on the Type B pole, and make sure the poles click
securely into place.
Type B Pole Type A Pole
4
Slide the side hems of the tunnel floor over the bottom poles.
Use the 150mm Cable Ties to secure the tunnel
6
floor to the frame.
Attatch Type C poles to the 3-way connectors creating a
2
frame end.
NOTE: On the top connectors, the flat side should be
facing up. While the bottom connectors, the flat side
should be facing down.
Flat Side
Flat Side
5
Attach the last frame end to complete the structure.
Slip the frame through the opening of the netting. Make sure
7
the corners of the net align with the corners of the frame.
3
Attach 4 assembled long poles into one frame end.
x2
Secure the open side of the tunnel netting with the 150mm Cable Ties.
8
Ensure there are no gaps large enough for your cat to escape.