BMW HP2 ENDURO Manual page 101

Only chargers suitable
7
for this mode of charging
can be used to recharge the
96
battery via the on-board sock-
et. Unsuitable chargers could
cause damage to the motor-
cycle's on-board electrics.
Use BMW chargers with
the part numbers 71 60
7 688 864 (220 V) or, as
applicable, 71 60 7 688 865
(110 V). If you are in doubt,
disconnect the battery from
the on-board systems and
z
connect the charger directly
to the battery.
If you switch on the ig-
nition and the multifunc-
tion display and telltale lights
fail to light up, the battery is
completely flat. Attempting to
charge a completely flat bat-
tery via the on-board socket
can cause damage to the mo-
torcycle's electronics.
If a battery has discharged to
the extent that it is completely
flat, it has to be disconnec-
ted from the on-board circuits
and charged with the char-
ger connected directly to the
battery posts.
Charge via the power sock-
et, with the battery connec-
ted to the motorcycle's on-
board electrical system.
Comply with the operating
instructions of the charger.
The motorcycle's
on-board electronics
know when the battery is
fully charged. The on-board
socket is switched off when
this happens.
Charging battery when
disconnected
Charge the battery using a
suitable charger.
Comply with the operating
instructions of the charger.
Once the battery is fully
charged, disconnect the
charger terminal clips from
the battery terminals.
The battery has to be re-
charged at regular inter-
vals in the course of a lengthy
period of disuse. See the in-
structions for caring for your
battery. Always fully recharge
the battery before restoring it
to use
Removing the battery
Note that the tripmeters
and the operating-hours
counter are reset to zero if the
battery is disconnected.
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Removing the seat (
If it is not standing firmly,
the motorcycle could
42)