Related Manuals for InWin RS112-08 HYBRID BP-GEN5
Summary of Contents for InWin RS112-08 HYBRID BP-GEN5
- Page 1 HYBRID BP GEN5/SAS4 USER’S MANUAL P/N : 2RAKVI015700 Model： ： ： ： RS112-08-HYBRID BP-GEN5 MODULE Version : V1.0 Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 1 OF 13...
-
Page 2: Revision History
Revision History Version Changes Date V1.0 Official Release 2024/08/27 Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 2 OF 13... -
Page 3: Table Of Contents
Host and Function Connector Location ..........8 Connector Pin Definitions..................8 Device Connector & LED Indicators............... 9 LED Behavior ................... 10 Disk Bay LED ......................10 Firmware Upgrade ................... 12 Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 3 OF 13... -
Page 4: Overview
For disk bays management, the backplane supports SGPIO protocol for SAS/SATA disks activity and status indication through SlimSAS connections on the board. It also supports UBM(Universal Backplane Management) for NVME disks activity and status indication through MCIO connections. Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 4 OF 13... -
Page 5: Physical Outlook & Diagram
Physical Outlook & Diagram... -
Page 6: Mechanical
Mechanical... -
Page 7: Hardware Specification
P4.2mm 2*4Pin Power Connector*1 (PW1 [+12V]). JM1 SMBUS Connector for external BMC SMBUS control function. JT1 Headers for UBM MODE & Test Mode Selection. JD1/JD2/JD3 Header for Programming MCU Firmware. Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 7 OF 13... -
Page 8: Host And Function Connector Location
： ： Connector Pin Definitions. -
Page 9: Device Connector & Led Indicators
Device Connector & LED Indicators. -
Page 10: Led Behavior
Disk Bay LED... - Page 11 NVMe disks. For example, NVMe1 and NVMe2 LED management signal is form NVMe1 connector’s sideband I2C bus, NVMe3 and NVMe4 LED management signal is from NVMe3 connector’s sideband I2C bus and …etc. Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 11 OF 13...
-
Page 12: Firmware Upgrade
1. Require Nuvoton ARM Cortex-M0 programming tool. Nu-Me or Nu-Link and install Nuvoton ICP Programming tool software. 2. Connect Nu-Link USB end to a host and the SWD end to Backplane ICE connector for each MCU. Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 12 OF 13... - Page 13 3. Make sure device is connected and select the binary file being programmed and then click on Start button to program firmware. 4. Please refer to http://www.nuvoton.com/resource- files/NuLink_Adapter_User_Manual_EN_V1.01.pdf for more details. Model : RS112-08 HYBRID BP-GEN5 User’s Manual PAGE 13 OF 13...
Need help?
Do you have a question about the RS112-08 HYBRID BP-GEN5 and is the answer not in the manual?
Questions and answers