AllSee PF22 Installation Manual

PF22 Mounting Plate Installation Guide
▪This guide explains how to install the mounting plate using the screw fixing method. Structural
adhesive fixing is another option, but this guide focuses solely on screw fixing.
▪The mounting plate is pre-installed on the back of the screen at the factory. Users must prepare
Accessory 3 independently.
Required Accessories for Installation
1.Mounting Plate × 1
(Anti-theft screws are pre-installed on the mounting plate at the factory.)
2. Mounting Bracket Installation Guide × 1
3. M3 Countersunk Expansion Screws × 8
(Users must source this accessory themselves.)
Safety Precautions
· Refer to the provided installation diagram and included accessories.
· Follow the installation steps as a reference.
· Ensure all screws are securely tightened.
· Use the equipment within the specified size and weight limits for safety.
· Install on a flat wall.
· Important: For wooden walls, ensure the wall thickness is at least 3 cm and the
load-bearing capacity is 100 kg.
· Suitable for 22" installations.
Installation Steps
Secure the mounting plate to a solid, load-bearing wall using M3
S t ep 1
screws × 8. The plate supports both horizontal and vertical
installations.
For horizontal installation, the hanging tongue on the short side of the plate
should face right.For vertical installation, the hanging tongue on the short
side should face down.
Vertical UP label
M3 screw × 8
Make sure the screw heads are flush with or lower than the surface
S t ep 2 of the hanging plate.
Vertical UP label