Advertisement
Quick Links
Advertisement
Related Manuals for AllSee LHDS
Summary of Contents for AllSee LHDS
- Page 1 LHDS Setup Revision date: 19/08/20...
- Page 3 Instructions Please read entire instruction sheet before you start. You will need: 1x Set of Hexagonal Keys (Allen Keys) 1x Small Phillips Screwdriver/Drill Step 1 Begin by assembling the base using Parts “B”, “C” and “F” (see Figure 1). Do not attach one of the “B” Parts at this stage to allow access to any screws that may fall through the base during assembly.
- Page 4 Step 2 There will be 6 large-headed screws in an accessory bag for the screen. Replace 3 of the standard screws on both edges of the screen with these large-headed screws (see Figure 2). Note: This example is for the 55” version of this display. For the 43” version, only 2 screws are needed either side, at the top and bottom.
- Page 5 Step 3 Take both of the “A” Parts that will attach to either side of the screen and remove the inner connector rods (see Figure 3). Figure 3...
- Page 6 Step 4 Attach the inner rods to the base, in the centre of the “C” Parts (see Figure 4). Note: There will be 2 holes on either side of both of these inner rods. The holes on one side are for standard screws, whereas the holes on the other side will have a larger area around the screw holes for large-headed screws.
- Page 7 Step 5 Attach the inner rods, which should be attached to the base, to the side poles (“A” Parts), which should be attached to either side of the screen (see Figure 5). Figure 5...
- Page 8 Step 6 Secure the side poles (“A” Parts) to the base properly by attaching the security poles (Parts “D” and “E”; see Figure 6). The “E” Parts will be secured with standard screws only (see Figure 7). The “D” Parts will slot onto the “A” Parts with large-headed screws (see Figure 8) and then be screwed onto the base (see Figure 9).
- Page 9 Figure 7 Screwing “E” Parts onto “A” Parts and base Figure 8 Holes in “A” Parts for slotting on large-headed screws of “D” Parts...
- Page 10 Figure 9 Screwing “D” Parts onto base Figure 10 Base securely attached to side poles using security poles...
- Page 11 Step 7 When the base is secured to the side poles (“A” Parts), the final “B” Part can now be attached. Step 8 To assemble the top of the stand, begin by attaching 3 pieces: the final “B” Part, and the 2 “G” Parts.
- Page 12 Step 9 Slot the assembled “B” and “G” Parts onto the top of the “A” Parts, and then carefully lift this frame to sit on the base. Finally, secure the “G” Parts to the side poles (“A” Parts) using the screws provided (see Figure 12).
Need help?
Do you have a question about the LHDS and is the answer not in the manual?
Questions and answers