PALECEK Glacier 148205 Mounting Instructions

These instructions are provided for your convenience. It is very important that they are read carefully and completely before beginning
installation of this item.
Tools Needed:
Drill, Philip head screw bit, Measuring tape, Hammer, Bubble Level, and Pencil
Parts List:
A) Wall Decor x 1pc.
B) Metal Cleat x 4pcs.
C) Wall Screw x 8pcs.
D) Wall Anchor x 8pcs.
To Assemble
1. Remove all parts and hardware from the box along with any plastic protective packaging. Do not discard contents until after assembly
is complete to avoid accidentally discarding small parts or hardware.
2. Place components on a non-scratching surface.
3. Determine the desired orientation of the Wall Shelf. Wall Shelf is equipped with two (2) Metal Cleats for hanging.
NOTE: Make sure the place where the wall shelf will be attached is leveled before attaching the metal hooks.
4. Using the guide sheet provided, place it in the desired wall location. Use a bubble leveler to ensure level positioning. Stick the guide
sheet into the wall.
5. Using the drill, pre-drill holes at marked locations.
NOTE: If Wall Shelf location will be installed in sheet rock or masonry, use appropriate drill bit size to accommodate wall anchors at
locations between wall studs. Using a hammer, gently tap anchors into the holes until they are flush with the wall.
Anchors provided are for sheet rock. For masonry anchors, consult your local hardware store.
6. Remove the guide sheet and place Wall Anchors on hole locations, then place the Metal Cleats and insert screws accordingly.
MOUNTING INSTRUCTIONS
Glacier Wall Shelf 36"
148205
Side View of cleat engagement