TREX TMA-9H User Manual

Portable hydraulic lift

Advertisement

Quick Links

Portable Hydraulic Lift – TMA-9H
User Manual
[Revision 1.0 February 2019]
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY
DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by
this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
E&OE
© 2019 Trex

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TMA-9H and is the answer not in the manual?

Questions and answers

Summary of Contents for TREX TMA-9H

  • Page 1 Portable Hydraulic Lift – TMA-9H User Manual [Revision 1.0 February 2019] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
  • Page 2: Safety

    Portable Hydraulic Lift – TMA-9H Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols: You WILL be KILLED or...
  • Page 3 Portable Hydraulic Lift – TMA-9H General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must • The equipment must be serviced or cords, power bars, and electrical fittings have an approved cord and plug and repaired at authorised service centres for damage or wear before each use.
  • Page 4 Portable Hydraulic Lift – TMA-9H Lift only those areas of the automotive vehicle specified by its manufacturer. Immediately after lifting load, ensure lift mechanical load holding means is engaged Before moving, lower the load to the lowest possible point. Secure load with appropriate restraint device.
  • Page 5: Safety Symbols

    Portable Hydraulic Lift – TMA-9H Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc, replace them. Flammable Material Hazard...
  • Page 6 Portable Hydraulic Lift – TMA-9H Carbon-Monoxide Hazard Pull Hazard Slope / Fall Injury Hazard "Slam Dunk" Warning Do not use the product in Be aware that the product Be aware that using the Do NOT attempt "slam dunk" confined areas or without...
  • Page 7: Table Of Contents

    Portable Hydraulic Lift – TMA-9H Table of Contents Safety ..............................2 Safety Symbols ............................5 Parts Identification ..........................8 Assembly ............................9 Operation ............................9 Raising the Load ............................9 Lowering the Load............................9 Securing the Load ............................ 10 Releasing the Load ..........................10 Maintenance .............................
  • Page 8: Parts Identification

    Portable Hydraulic Lift – TMA-9H Parts Identification Name Qty. Name Qty. Base Washer 8 Link Spring washer 8 Lift saddle Bolt M8x20 Connecting rod BoltM8x25 Handle Locking Rod 15x80 Locking screw Washer 16 Return spring Locking pin Hydraulic ram Bolt M5x25...
  • Page 9: Assembly

    Portable Hydraulic Lift – TMA-9H Assembly 1. Place hydraulic ram (H) onto the base (A) using 2 MBx25 hex bolts (4), 2 spring washers (2), 2 washers (1) and using bolt M5x25 (B) to fix the ram to the connecting rod (D), then tighten.
  • Page 10: Securing The Load

    Portable Hydraulic Lift – TMA-9H Securing the Load 1. Connect strap hooks to loop (P) and place strap over load. 2. With the strap Handle (A) in the closed position, take long strap end and slip it through the slot insertion in Spindle (B).
  • Page 11: Maintenance

    Portable Hydraulic Lift – TMA-9H Maintenance IMPORTANT: Before performing any maintenance of the bottle jack ALWAYS detach from the frame and place on a level surface. Air Purging Instructions With the ram fully retracted, locate and remove the oil filler plug. Insert the foot pedal into the sleeve of the Hydraulic Ram, then pump 6 to 8 strokes.
  • Page 12: Troubleshooting

    Portable Hydraulic Lift – TMA-9H Troubleshooting TROUBLE CAUSE REMEDY Air in hydraulic system. Purge air from hydraulic system.   Jack will not lower completely. Release valve stuck. Transfer weight load and clean valve.   Jack will not hold weight Release valve in open position.
  • Page 13 ©2019 Trex. All rights reserved. No part of this document, including descriptive content, concepts, ideas, diagrams or images may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, scanning or recording, or any information storage and retrieval system,...

Table of Contents