SImx FAN5653 Installation Instructions

INSTALLATION INSTRUCTIONS
Fast Dry Hand Dryer
FAN5653 / FAN5654
Thank you for purchasing the Simx Fast Dry hand dryer. It requires a 230V AC power supply to operate
and should be installed by a registered electrician. Please read this manual thouroughly before installation
and retain for future reference.
TECHNICAL SPECIFICATIONS
Power Source
Power Frequency
Power
Air Speed
Drying Distance
Dimensions
!
IMPORTANT
All installations and electrical work must comply with current local and national electrical and
building regulations as applicable. Electrical work should only be carried out by a registered
electrician.
Ensure that the unit is installed on a suitably rated fused circuit with the supply isolating switch
having a minimum contact separation of at least 3mm.
If the supply cord is damaged, it must be replaced by the manufacture, its service agent or similar
qualified persons in order to avoid a hazard.
This dryer is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that they do not play with this appliance.
Do not insert objects into the air outlets. Doing so may be hazardous and could result in electrical
shock.
Do not obstruct the air inlets or outlets in anyway.
Service hand dryer at regular intervals.
The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction.
220-240VAC
50-60Hz
1100W
90 m/s
12cm (+/- 3cm)
248 x 174 x 250mm