SImx FAN6855 Installation Instructions

Installation Instructions
Rapid Dry Stainless Steel Hand Dryer
FAN6855
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING
THE INSTALLATION

IMPORTANT

All installations and electrical work must comply with current local and national
electrical and building regulations as applicable. Electrical work should only be
carried out by a registered electrician.
Ensure that the unit is installed on a suitably rated fused circuit with the supply
isolating switch having a minimum contact separation of at least 3mm.
The product has an internal 10A fuse.
If the supply cord is damaged, it must be replaced by the manufacture, its
service agent or similar qualified persons in order to avoid a hazard.
This dryer is not intended for use by young children or infirm persons without
supervision.
Young children should be supervised to ensure that they do not play with this
appliance.
Do not insert objects into the air outlets. Doing so may be hazardous and could
result in electrical shock.
Do not obstruct the air inlets or outlets in anyway.
Service hand dryer at regular intervals.
The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience or knowledge,
unless they have been given supervision or instruction.

Technical Specification:

Voltage:
Power:
Input:
Air Speed:
Drying Distance:
Safety:
Protection Class:
Dimensions:
220 – 240 VAC
500W
1150 – 1350W
216 km/hr
15-20 cm
Class I
IPX1
253 (H) x 172 (W) x 145 mm (D)