Table of Contents
Advertisement
Quick Links
Operating manual
Publish Date: 2023-XX-XX
v1.0
Wireless sensor
Operating manual
ELT series
ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden
E-mail:
support@elsys.se
ǀ Web:
www.elsys.se
Specifications in this document are subject to change without notice.
©ElektronikSystem i Umeå AB 2022
Advertisement
Table of Contents
Related Manuals for Elsys ELT Series
Summary of Contents for Elsys ELT Series
- Page 1 Operating manual Publish Date: 2023-XX-XX v1.0 Wireless sensor Operating manual ELT series ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se Specifications in this document are subject to change without notice. ©ElektronikSystem i Umeå AB 2022...
- Page 2 Operating manual ELT series Important safety information Read this manual before attempting to install the device! Failure to observe recommendations included in this manual may be dangerous or cause a violation of the law. The manufacturer, ElektronikSystem i Umeå AB will not be held responsible for any loss or damage resulting from not following the instructions of this operating manual.
-
Page 3: Table Of Contents
Product information ..................1 Description ..................1 ELT Series attributes ................. 1 Label ....................1 Dimensions (mm) ................2 Main features of the ELT series ............3 Mounting guidelines ................... 4 Ultrasonic and Snow ................. 4 Installation ....................5 NFC Configuration ................6 Over the air configuration .............. - Page 4 Operating manual ELT series External Sensors..................14 Device specifications ................15 Sensor payload format ................16 Regulations....................16 Legal Notices ..................16 Declaration of conformity ..............16 Federal Communication Commission Interference Statement ....16 Revision History ................... 18 ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se...
-
Page 5: Product Information
® in- and outdoor use. The internal sensors measure, depending on model, temperature, humidity, atmospheric pressure, distance, and acceleration. The ELT series are also equipped with multi-purpose I/O for connection to external sensors and equipment. The sensors are equipped with NFC (Near Field Communication) for easy configuration with an NFC-enabled smartphone. -
Page 6: Dimensions (Mm)
Operating manual ELT series 1.4 Dimensions (mm) ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 7: Main Features Of The Elt Series
Operating manual ELT series 1.5 Main features of the ELT series • Compatible with LoRaWAN specification 1.0.3 ® • IP67-rated • Measures ambient temperature* • Measures ambient humidity* • Measures atmospheric pressure* • Measures acceleration* • Measures distance* • Multi-purpose I/O** •... -
Page 8: Mounting Guidelines
Operating manual ELT series 2. Mounting guidelines Common mounting guidelines for ELT line of sensors: • For best RF and measurement performance, make sure you mount the sensor with the antenna vertically. • If external wiring is to be connected to the sensor and the sensor is to be placed in environments where it may get wet, consider water runoff, and place the sensor with the cable gland placed vertically. -
Page 9: Installation
Operating manual ELT series 3. Installation 1. Remove the front lid. 2. Install the battery. The ELT requires one AA battery. The battery type is 3.6V Lithium Battery (ER14505). Caution: Using batteries other than the ones provided may result in loss of performance, battery life, and also damage to the device. -
Page 10: Nfc Configuration
NFC to make end-users unable to read or change settings on the sensor. 3.1 NFC Configuration 1. Download ELSYS “Sensor Settings” application from Google Play or App store and install it on a smartphone or tablet. The device must support NFC. -
Page 11: Over The Air Configuration
Operating manual ELT series 3.2 Over the air configuration All settings may be configured over the air via your LoRaWAN infrastructure. ® Please visit the support section on our webpage for more information regarding downlink protocol. 3.3 Application parameters All parameters for the “Sensor settings” application can be found in our settings document. -
Page 12: Sensor Behavior
Operating manual ELT series 4. Sensor behavior 4.1 Sensor startup 1. When the sensor starts up it loads any configuration parameters written to the NFC chip. The sensor will then write all configuration parameters back to the NFC chip. 2. When the configuration is done the sensor tries to join the network if OTAA (Over the Air Activation) is enabled. -
Page 13: Led Indication
Operating manual ELT series 4.4 LED indication The LED, located in the bottom right corner on the PCB, indicates different actions when the sensor is active. LED indication Action Long red blink, long green blink Sensor is starting up Short yellow blink... -
Page 14: Internal Sensors
Operating manual ELT series 5. Internal sensors The populated internal sensors in the ERS2 series differ between models according to the list below. ELT Lite ELT 2i ELT 2 Temperature Humidity Atmospheric pressure Accelerometer Multi-purpose I/O 1 (IN) Multi-purpose I/O2 (I/O2) ElektronikSystem i Umeå... -
Page 15: Temperature
Operating manual ELT series 5.1 Temperature Resolution: 0.1 °C Accuracy: 0.2 °C typical, see figure 5.2 Humidity Note that the internal sensor will react very slowly to external changes in humidity. The humidity sensor can be somewhat helped by equipping the ELT with a... -
Page 16: Atmospheric Pressure
Operating manual ELT series 5.3 Atmospheric Pressure Note that the ELT2 is equipped with a cable gland with a pressure membrane, which allows for atmospheric pressure reading while keeping its IP 67 rating. Atmospheric pressure Range: 260 – 1260 hPa Accuracy: ±... - Page 17 Operating manual ELT series ElektronikSystem i Umeå AB Tvistevägen 48C, 90736 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se...
-
Page 18: External Sensors
Operating manual ELT series 6 External Sensors The ELT series of sensors can be connected to a wide array of external sensors, equipment, and modules. All connections to external gear are made available through the terminal block located on the top left of the circuit board inside the ELT. -
Page 19: Device Specifications
Operating manual ELT series 7 Device specifications Mechanical specifications Dimensions 94 x 59 x 35 mm Weight 60g / 97g (with battery inserted) Enclosure Polycarbonate IP rating IP67 Mounting Screws / Adhesive tape Operating conditions Usage environment Indoor, Outdoor Temperature –40 to 60 °C (85 °C with external power... -
Page 20: Sensor Payload Format
All information, including, but not limited to, information regarding the features, functionality, and/or other product specification, are subject to change without notice. ELSYS reserves all rights to revise or update its products, software, or documentation without any obligation to notify any individual or entity. ELSYS and ELSYS logo are trademarks of ElektronikSystem i Umeå... - Page 21 Operating manual ELT series Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
-
Page 22: Revision History
Operating manual ELT series this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •...
Need help?
Do you have a question about the ELT Series and is the answer not in the manual?
Questions and answers