VARILITE VL800 BEAMLINE Quick Start Manual

VL800 BEAMLINE
OVERVIEW
This document provides basic setup instructions and safety
warnings for the following product(s):
VL800 Beamline, black
INSTALLATION AND SETUP
CONNECTING POWER
This fi xture requires standard AC power distribution from 200-240VAC, 50/60 Hz. Current required
depends on the AC supply voltage and product model.
The mating Neutrik® powerCON® True1 connector is supplied; however, you will need to purchase or
NOTE:
construct a cable appropriate for your application.
Depending on the application, the luminaire's AC input cable may require
a diff erent connector. If required, install a new connector meeting your
requirements using the following wire color code reference:
WIRE*
Green/yellow
Blue
Brown
* International (Harmonized) Standard
WARNING:
X
G
Y
CURRENT VERSUS VOLTAGE
provides the luminaire's current draw at
TABLE 1
specifi c voltages. Total luminaire current is calculated
with the lamp on and all motors sequencing.
CONNECTING DATA
A maximum of 32 luminaires may be connected in
any one DMX data link.
This maximum limit applies to the luminaire "daisy
NOTE:
chain" only. Your system or console may require fewer
luminaires on a single data link path. Consult your console
documentation for more information.
CONNECTION
AC ground
AC neutral
AC line
DO NOT connect to three-phase service in countries with 240V power.
Single-phase power at 240V RMS:
CONNECTION
AC neutral
AC line
Ground (earth)
88-105-7290-00
PIN
X
Y
G
TABLE 1. CURRENT VS. VOLTAGE (230W LED)
AC VOLTAGE
AT 60HZ
1
QUICK START GUIDE
88-105-7290-00 REV 00 MAY 5 2022
INCLUDED ITEMS
QUICK START
GUIDE
VL800 BEAMLINE
Three-phase power at 200V RMS:
CONNECTION
Phase 1
Phase 2
Ground (earth)
TOTAL LUMINAIRE CURRENT
(MOTOR + LAMP CURRENT)
200V 1.4A
210V 1.3A
220V 1.25A
230V 1.2A
240V 1.15A
POWER
CONNECTOR
WARRANTY
CARD
PIN
X
Y
G