Generac Power Systems CorePower 6/7 kW 60 Hz Diagnostic Repair Manual page 106

Section 5.1
Major Disassembly
2
Figure 136.
f. Remove 2x4 wood block from under the alternator air duct
and tighten vibration isolator nuts.
3. Continue Reassembly:
a. Install the divider panel (with muffler attached) and tighten
screws.
b. Tighten exhaust flex pipe clamp.
c. Install the right side (alternator end) enclosure.
d. Install battery and battery access panel.
e. Install rear and front access panels.
f. Install roof.
4. Perform operational tests.
Page 104
1
4
3
PART 5
Torque Values
Stator Bolt
Rotor Bolt
M5 x 0.8 Screw On Band Clamp
M6 x 1.0 Screw On Band Clamp
M6 x 1.0 Screw Flange Nuts - Airbox to Cylinder Head
M8 x 1.0 Nuts - Exhaust to Cylinder Head
M8 x 1.25 Vibration Isolator to Base
M10 x 1.25 Engine to Vibration Isolator
3/8-16 Screw to Mounting Foot
M6 x 1.0 Nyloc Nut on Dead Front Plate
M3 x 0.5 Screw into Aluminum
M3 x 0.5 Taptite Screw into Extruded Hole
M5 x 0.5 Screw into Aluminum
M5 x 0.8 Taptite Screw into Extruded Hole
M6 x 1.0 Screw into Aluminum
M6 x 1.0 Taptite Screw into Extruded Hole
M8 x 1.25 Taptite Screw into Extruded Hole
DISASSEMBLY
6-7 ft-lbs
27-33 ft-lbs
7.5-9 ft-lbs
14-15 ft-lbs
7-8 ft-lbs
20-22 ft-lbs
20-22 ft-lbs
15-20 ft-lbs
5-8 ft-lbs
40-50 in-lbs
8-10 in-lbs
8-18 in-lbs
25-35 in-lbs
25-50 in-lbs
50-60 in-lbs
50-96 in-lbs
15-20 ft-lbs