Ranch Hand RSF991C8B6S Installation Manual

INSTALLATION MANUAL
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Parts List
Qty Description
1 Driver / left running board
1 Passenger / right running board
12 Bolt, M8
12 Flat washer, M8
6 Clip nut, M8
6 Flange nut, M8
6 Lock washer, M8
Tools Required
Wrench / socket, 1/2" --
Torque Specifications
M8 bolt 17 - 20 ft-lbs.
Use above torque setting unless otherwise noted
Product Registration and Warranty
Ranch Hand stands behind our products
with industry-leading warranties. To get
copies of the product warranties, register
your purchase or provide feedback, visit:
warranty.curtgroup.com/surveys
RANCHHAND.COM
PRODUCT SUPPORT: 877.287.8634
•
Product Photo
Product Photo
NOTICE
Visit www.ranchhand.com for a full-color copy of this
instruction manual, as well as helpful videos, guides and much more!
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Periodic inspection of your product should be performed
to ensure all hardware and / or components remain secure.
These running steps are engineered and manufactured specifically for
driver and passenger sides of your vehicle. The short, 45 bend and the
largest step (18") is installed towards the front of the vehicle. For straight cut
bed access step models, the striaght cut is installed to the rear of the vehicle.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Maintenance
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
RSF99-INS-RA 11/21/2022
• •
Front
Front
°
ECN9841 PAGE 1
• •
Rear
Rear