Advertisement
Quick Links
INSTALLATION MANUAL
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Parts List
Qty Description
1
Driver / left running board
1
Passenger / right running board
6
Bolt plate
24
Bolt, M8
24
Flat washer, M8
12
Serrated flanged nut, M8
12
Lock washer, M8
Tools Required
Socket, 1/2"
Wrench, 1/2"
Torque Specifications
M8 bolt
15 ft-lbs.
Use above torque setting unless otherwise noted
Product Registration and Warranty
Ranch Hand stands behind our products
with industry-leading warranties. To get
copies of the product warranties, register
your purchase or provide feedback, visit:
warranty.curtgroup.com/surveys
RANCHHAND.COM
PRODUCT SUPPORT: 877.287.8634
•
Product Photo
Product Photo
NOTICE
Visit www.ranchhand.com for a full-color copy of this
instruction manual, as well as helpful videos, guides and much more!
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Periodic inspection of your product should be performed
to ensure all hardware and / or components remain secure.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Maintenance
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
RSD09-INS-RA
11/21/2022
•
•
Front
Front
ECN9592
PAGE 1
•
•
Rear
Rear
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ranch Hand RSD091C1B4S
Summary of Contents for Ranch Hand RSD091C1B4S
- Page 1 M8 bolt 15 ft-lbs. Use above torque setting unless otherwise noted Front Product Registration and Warranty Ranch Hand stands behind our products with industry-leading warranties. To get NOTICE copies of the product warranties, register your purchase or provide feedback, visit: Visit www.ranchhand.com for a full-color copy of this...
- Page 2 Step 1 Locate the driver side running step. Step 2 Locate the mounting holes underneath the body and remove the factory tape from the three locations. Step 3 Insert the supplied threaded U-clips in each mounting location. Note: Clip orientation will be he same for passenger side.
- Page 3 Finish by tightening the upper attachments points to 20 ft-lbs. from front to back. Repeat steps 2 through 8 on the passenger side of the vehicle. To protect your investment, see the 'Notes and Maintenance' section on page one. Congratulations on the installation of your new Ranch Hand ™ running steps.
Need help?
Do you have a question about the RSD091C1B4S and is the answer not in the manual?
Questions and answers