Page 1
Equipment sheet Eboli AL II with exchanger Eboli AL II with exchanger Equipment sheet Fireplace stove with exchanger 0332315961400–...
Page 2
Introduction We thank you very much for purchasing our product! The description of the heating device will inform you in detail about the design, technical specification and operation of the heating device. We recommend you to acquaint yourselves closely with these data. In this way, you will avoid possible faults during the proper assembly and operation.
1. Technical specification Suitable fuels: As concerns suitable fuel to be employed, see the chapter 2.2 Fuel in the General Manual of Operation. Správný provoz: As concerns the proper and safe operation of the fireplace stove, see the chapters 2. Description of the combustion process and 5.
2. Technical description Pozice Název Přívod primárního vzduchu Přívod sekundárního vzduchu Výstup terciálního vzduchu Externí přívod vzduchu (Ø 100 mm) Regulátor sekundárního vzduchu Regulátor primárního vzduchu...
3. Overview of spare parts 3.1. Whole emplacement...
Page 8
Spare part number Item Name Piece Fire-box door (complete)/black 1 piece 0332315025300 Strip connecting material - set 1 piece 0089931140005 Automatic air control (flap) 1 piece 0431317006601 1 piece Smoke flue neck/black 0470315005007 Flue gas duct packing cord 10x4 mm 480 mm 0040210040005 Flue gas duct blind flange/black...
3.2. Detail A1 Spare part number Item Name Piece Fire-box door hand pull 1 piece 0429415105318 A1.1. Hand pull connecting material - set 1 piece 0081010180005 A1.2. Door closing blade - set 1 piece 0331415017330 1 piece A1.3. Glass holder - set 0416515015304 Fire-box door (welded part)/black 1 piece...
4. Dimensioned diagram 4.1. Knee-piece of exhaust of combustion products Note The knee-piece of exhaust of combustion products is delivered as optional accessory.
4.2. Connection of the exchanger WARNING The automatic venting valve (item C) must be always connected! Item Name Heating water output (inner thread G1) Return water intake (inner thread G1) Hole for venting valve (inner thread G1/2) Well of the thermo-static sensor (Automatic air control - flap)
7. Heat exchanger cleaning instructions IMPORTANT Basic cleaning with wiping bar must be performed approximately 1x per week. General cleaning of the exchanger should be performed at least 1x per heating season or more often, depending on the way of operation. select a suitable cleaning tool to clean the exchanger surfaces (fig. A). when performing general cleaning, dismount carefully the body cover (pos.
Page 17
Note When exchanging the cleaning sides, pos. 5 is exchanged for pos. 1 (fig. B2, A2). The cleaning procedure applies also for the opposite side. Spare part number Item Name Piece 1 piece Screw M10x70 0030031000705 Allen wrench 8 mm (forms part of the delivery) 1 piece 9001700080005 Drawbar of cleaning/black...
Page 18
WARNING When terminating the cleaning, always arrest the wiping bar. Do not leave the wiping bar over the flame and the (a, b) holes freely passable.
Need help?
Do you have a question about the Eboli AL II and is the answer not in the manual?
Questions and answers