Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gardena smart SILENO free
Summary of Contents for Gardena smart SILENO free
- Page 1 Operator’s manual smart SILENO free gardena.com...
-
Page 2: Table Of Contents
8.3 Disposal.............. 35 2.1 Introduction............6 9 Technical data 2.2 Product overview...........7 9.1 Technical data.............36 2.3 System overview for smart SILENO free 9.2 Registered trademarks........37 installation..............8 10 Declaration of Conformity 2.4 Connectivity overview........... 9 10.1 Original EU Declaration of Conformity....38 2.5 To use the keypad..........9... -
Page 3: Safety
Operation on page 21 . area of the product if it operates in public areas. • If there is a risk of thunderstorm, GARDENA The signs must have the text that follows: Warning! recommends that the power supply is Automatic lawn mower! Keep away from the... -
Page 4: Safety Instructions For Installation
To set the product in the mowing area. Refer to with its special characteristics and safety to OFF on page 23 . GARDENA recommends to regulations. set the product to operate when the mowing has •... -
Page 5: Battery Safety
1.6 Battery safety WARNING: Read the warning instructions that follow before you use the product. • Lithium-ion batteries can explode or cause fire if disassembled, short-circuited, exposed to water, fire, or high temperatures. Handle carefully, do not dismantle, open the battery or use any type of electrical/mechanical abuse. -
Page 6: Product Description
Product overview on page 7 . The serial number is on the product carton and on the product rating plate. Refer to • Use the serial number to register your product on www.gardena.com. 2.1.1 Support 2.1.2.2 Connectivity Install the Gardena smart Gateway and connect the For support about the GARDENA product, speak to your product to use the GARDENA smart system App. -
Page 7: Product Overview
21. GARDENA smart Gateway LAN-cable Contact plates 22. GARDENA smart Gateway 10. LED for operation check of the charging station 23. GARDENA smart Gateway power supply 11. Rating plate 24. Operator’s Manual, Quick Guide and instruction for the GARDENA smart system 12. -
Page 8: System Overview For Smart Sileno Free Installation
2.3 System overview for smart SILENO free installation Virtual boundary No-go zones Mowing areas Robotic lawn mower Charging station Docking point 8 - Introduction 2516 - 001 -... -
Page 9: Connectivity Overview
Use the ON/OFF button (A) to set the product to ON or OFF. • Use the Connectivity button (B) to enable the pairing operation for the GARDENA smart system. • Use the Start button (C) to start the operation of the product according to schedule. - Page 10 2.5.1 LED status indicator on the keypad The LED status indicator on the keypad shows the status of the product. There are 3 light modes on the LED indicator: the light flashes quickly (A), the light is solid (B), the light is out (C), and the light pulsates (D). Standby.
-
Page 11: Symbols On The Product
Parked until the next schedule or Parked until further The product operates remotely by the app. notice . Error. Error after 3 minutes. Charging . 2.6 Symbols on the product These symbols can be found on the product. Study them carefully. -
Page 12: Symbols On The Battery
WARNING: Read the user instructions before operating the product. Read the user instructions. WARNING: Disable the prod- uct before working on or lift- Do not discard the battery into fire and do ing the product. not expose the battery to a heat source. WARNING: Keep a safe dis- tance from the product when Do not immerse the battery into water. -
Page 13: Introduction - Installation
60–300 CAUTION: Use original spare parts and cm / 24–118 in. GARDENA recommends to have a minimum 6 m / 20 ft. (C) of free space in front of installation material. -
Page 14: To Examine Where To Put The Power Supply
If the virtual boundary has 2 parts separated with not operate. You can only have 1 virtual boundary a steep slope, GARDENA recommends to put the in an installation, but you can have several mowing charging station in the lower section. - Page 15 Note: Trees or a group of trees with tree canopies that are more than 4 m / 13 ft. in diameter (A) can cause temporary stops for the product. Smaller trees do usually not cause interference with the operation of the product. •...
-
Page 16: Installation Of The Product
• Make sure that the No-go zone includes the WARNING: Make sure that the plugs of complete area (A) where the product must not the low-voltage cable and the power supply enter. unit are clean and dry before you connect them. - Page 17 10. Put the low-voltage cable in the ground with stakes or bury the cable. 11. Attach the charging station to the ground with the supplied screws. 3.2.2 To do a visual check of the charging CLICK! station Make sure that the indicator LED lamp on the charging station has a green light.
- Page 18 Installation of mowing areas and No-go zones. Refer to the map on page 14 . Use the GARDENA smart system App and operate the product with Remote control when you set waypoints. Follow the instructions in the app and refer to To operate the product with Remote control on page 19 .
- Page 19 You do not have to use Remote control to install mowing areas. 3.2.5.3 To install a No-go zone Open the GARDENA smart system App and select No-go zone. Operate the product counterclockwise around the selected area and set the waypoints for the No-go zones.
-
Page 20: Settings
4 Settings Along mowing area edge makes the product Use the GARDENA smart system App for product • settings. operate with the cutting pattern for the Trim-to- Edge function by the boundary wire. 4.1 To do the Schedule settings On collision makes the product operate with the •... -
Page 21: Operation
5 Operation 5.1 To use the ON/OFF button 5.3 Operating modes The following operating modes are available: WARNING: Read and understand the • Mowing according to schedule safety chapter before you use the product. Override schedule • SpotCut • • Push the ON/OFF button for 3 seconds to set the Park / Schedule •... -
Page 22: Park / Schedule
Push the STOP button. Push the Park button for 1 second. Push the OK button. 5.3.3 SpotCut Push the OK button. Use the SpotCut function to quickly cut an area where Note: the grass has been cut less than in other parts of To change the operating mode of the product, the yard. -
Page 23: To Set The Product To Off
Put the product into the charging station until the charging plates touch the contact plates. Make sure that the product charges in the GARDENA smart system App or on the keypad. Release the cutting disc. Attach the cover of the cutting height adjustment knob. - Page 24 CLICK! 24 - Operation 2516 - 001 -...
-
Page 25: Introduction - Maintenance
CAUTION: Do not use a high-pressure washer to clean the product. Do not use solvents for cleaning. GARDENA recommends to use a special cleaning and maintenance kit. Speak to your GARDENA service for more information. 6.3.1 To clean the product Push the clips that are on the rear side of the body of the product. -
Page 26: Replacement Of The Blades
Do not remove other parts from the product to clean it. WARNING: GARDENA can only guarantee safety if you use GARDENA Clean the body of the product and the chassis with original blades with the embossed crowned a brush and running water. -
Page 27: Firmware Update
6.5.2 Update of the GARDENA smart system App The GARDENA smart system App is regularly updated. Update the app on App Store or on Google Play to make sure that you have the latest version. Push the clips that holds the battery and lift up the 6.6 Battery... - Page 28 Service usually includes the following: • Thorough cleaning of the body, the chassis, the blade disc and all other moving parts. • Testing of the product’s function and components. • Checking and, if required, replacing wear items such as blades and bearings. •...
-
Page 29: Troubleshooting
7 Troubleshooting 7.1 Messages The messages in the table below are shown in the app. Speak to your GARDENA servicing dealer if the same message shows frequently. Message Cause Action Wheel motor blocked, left/ Grass or other object around the drive Remove grass or other object. - Page 30 Remove or cre- ate an island around objects that can cause the chassis to be lifted. If the prob- lem stays speak to your GARDENA serv- ice. Wheel drive problem, right/ Grass or other object around the drive Clean the wheels and around the wheels.
- Page 31 Action Battery problem Temporary battery or firmware related Restart the product. If the problem stays problem in the product. speak to your GARDENA service. Incorrect type of battery. Use original batteries recommended by the manufacturer. Battery temperature out- The temperature in the battery is too high...
- Page 32 Message Cause Action Destination blocked The way of the destination is blocked by an Remove the obstacle that blocks the way to obstacle. the destination. The way of the destination is blocked by a Edit or remove the No-go zone or make a No-go zone.
-
Page 33: Indicator Lamp In The Charging Station
Error in the circuit board or incorrect power supply in the charging station. 7.3 Symptoms If the product does not operate as usual, follow the symptoms table below. Speak to your GARDENA service if you cannot find the cause for the fault. - Page 34 Symptoms Cause Action The product is The product has operated the maximum cut- Usual operation for the product. Refer to do the Schedule settings on page 20 . parked for hours in ting time for the day. the charging station. The STOP button has been pushed.
-
Page 35: Transportation, Storage And Disposal
Note: If you keep the charging station outdoors, do not disconnect the power supply. • Speak to your GARDENA service for information about available storage accessories for your product. 8.3 Disposal • Obey the local recycling requirements and applicable regulations. -
Page 36: Technical Data
9 Technical data 9.1 Technical data Dimensions smart SILENO free Length, cm Width, cm Height, cm Weight, kg 10.8 Electrical system smart SILENO free Battery, Lithium-Ion 18.0 V/2.0 Ah Art.No 536 81 24-01, 536 81 24-02 Power supply (28V DC), V AC... -
Page 37: Registered Trademarks
Bluetooth Bluetooth SIG, inc. and any use of such word mark and logos are registered trademarks owned by marks by GARDENA is under license. App Store is a trademark of Apple Inc. Google Play is a trademark of Google LLC. -
Page 38: Declaration Of Conformity
10 Declaration of Conformity 10.1 Original EU Declaration of Conformity 38 - Declaration of Conformity 2516 - 001 -... -
Page 39: Eu Declaration Of Conformity
"Restriction of use of certain hazardous substances" and that the following standards and/or technical Huskvarna specifications are applied; R&D Director, Robotics & Smart Business Unit. • IEC 60335-1:2010+A1:2013+A2:2016 (EN Husqvarna AB, Gardena Division. Responsible for 60335-1:2012+AC:2014+A11:2014+A13:2017+A1 technical documentation. 5:2021) • IEC 60335-2-107:2017+A1:2020+A2:2021 (EN 50636-2-107:2015+A1:2018+A2:2020+A3:2021) •... -
Page 40: Applicable To Uk Market
11 Applicable to UK market 11.1 Original UK Declaration of Conformity 40 - Applicable to UK market 2516 - 001 -... -
Page 41: Statement Of Compliance
11.2 Statement of compliance 2516 - 001 - Applicable to UK market - 41... - Page 42 42 - Applicable to UK market 2516 - 001 -...
- Page 43 2516 - 001 - Applicable to UK market - 43...
- Page 44 ORIGINAL INSTRUCTIONS We reserve the right to make changes without prior notice. Copyright © 2024 GARDENA Manufacturing GmbH. All rights reserved. 1144036-26 2024-12-09...
Need help?
Do you have a question about the smart SILENO free and is the answer not in the manual?
Questions and answers