Gojo Purell ES10 Installation Instructions

DISPENSER INSTALLATION
WITH WALL FASTENERS
Open dispenser by pressing release buttons
on sides of dispenser and slide the front
cover down.
6"
Install dispenser with at least 6" of free space
below closed dispenser to allow for full access
to service the dispenser and ensure appropriate
hand-sensor clearance.
PURELL® ES10 SOAP AND HAND SANITIZER
TOUCH-FREE DISPENSER INSTALLATION
AND USE INSTRUCTIONS
Please read all instructions carefully before installing
and using the dispenser. Do not install in locations where
dispensers may be exposed to wet environments such
as showers or areas where walls are washed down.
Check for the correct product type. The label
inside dispenser needs to match the back
label on the refill.
SOAP/FOAM 10 = Soap Dispenser
SAN/FOAM 10 = Hand Sanitizer Dispenser
Using the dispenser as a template, pierce the tape
on the back plate to mark and drill four holes using
¼" drill bit. Use supplied wall anchor and #10 1"
screws to secure dispenser in place. Do not
overtighten. It is recommended to use 4 screws.
If only two are possible, the top two holes should
be used. Recommended holes shown.
SOAP
FOAM 10
SAN
FOAM 10