Lemon RX Gen 2 Programming Manual

Lemon RX Gen 2 Programming
1. Firmware Update: Ensure your transmitter's firmware is up to date before proceeding.
2. Binding the Transmitter to the Receiver:
a) Turn on your transmitter.
b) Navigate to the "bind" menu, but don't start the binding process yet.
c) Power on the Lemon RX Gen 2 receiver.
d) Press and hold the "B" button on the receiver until it flashes rapidly, then release.
e) Execute the binding process from the transmitter.
3. Channel Calibration: Check that the aileron, elevator, throttle, and rudder channels reach
-100/100 when you move the sticks fully in each direction. If not, set the gains back to 100%
for your selected mode.
4. Enable Telemetry:
•
Spektrum DX/NX Radios:
a) Access the "Function List" and select "Telemetry".
b) Scroll to an "Empty" slot and choose it.
c) Scroll to "Text Gen" and select it. Ensure the status is set to "Act" (active) instead of
"Inh".
d) Return to the main screen, then scroll right until you reach the "Lemon RX" telemetry
page.
•
Edge TX Radios:
a) Press the "SYS" button and select "Tools".
b) Choose "DSM Smart RX Telemetry", then select "TextGen".
Once enabled, the receiver's current settings will be displayed.
5. Power Cycle the Receiver: Unplug the receiver's power, then reconnect it.
6. Stick Calibration: Within 60 seconds of powering on, pull both transmitter sticks all the way
down and to the outside corners. Hold them until the display changes. Ensure the stick
movements are close to +100 or -100. If it's not working, check the % values in your
transmitter's display.