Easy and intuitive seven-segment LED display to represent gain adjusments – 1x8 analog video distribution amplifier with loopout Can fit up to 20 OG-DA-AV-MB in 2 RU with high density rear modules – Supports card-edge control of EQ and gain control –...
OG-DA-AV coupled PERFORMACE Gain OUTPUT Impedance 75Ω Level 1 Vp-p , nominal GENERAL Power Requirements +12 V, 210 mA idling Dimensions 325mm x 76.8mm Weight 135g 4.0 Rear Modules OG-DA-AV-RM OG-DA-AV-RM2 Dashboard Control Getting Started APANTAC LLC, 10200 SW ALLEN BLVD, BEAVERTON, OR 97005...
OG-DA-AV The Dashboard software is design to allow you to quickly access the feature sets of openGear form factor cards on a simple User Interface. This section will help you get up and running as quickly as possible. Running Dashboard...
OG-DA-AV 5.3.2 Coupling Mode Appendex A COPYRIGHT, TRADEMARK, and REGISTRATION All rights reserved by APANTAC LCC, Beaverton, Oregon, USA. No part of this document may be reproduced in any form or by any means without written permission from the product manufacturer. Changes are periodically made to the information in this document.
Page 7
OG-DA-AV equipment manufactured by others and supplied by Apantac. This hardware warranty shall not apply to any defect, failure, or damage: a) Caused by improper use of the Product or inadequate maintenance and care of the Product. b) Resulting from attempts by those other than Apantac representatives to install, repair, or service the Product.
Need help?
Do you have a question about the OG-DA-AV and is the answer not in the manual?
Questions and answers