Hozelock Green Power Evolution Manual page 5

Cooling Cycle
Before switching off the device, a cooling phase
is required.
If the cooling phase is not carried out, it may
damage the product over time.
Set the switch (4) to the "Cooling" position (Fig.2
item C) for at least 30 seconds.
After this time, move the switch to OFF (Fig.2
item A) to switch off the GREEN POWER
EVOLUTION.
Storage
Disconnect the device from the power supply.
Check the device is completely cold before
storing it.
It can then be stored horizontally on the ground
on its stand (Fig.1 item 7) or hung to the wall by
its hanging point (Fig.1 item 2).
Maintenance
The product can be cleaned with a damp cloth
and mild detergent, but do not allow any water
to enter the product.
There are no user serviceable parts on the
GREEN POWER EVOLUTION.
For any queries, please contact Hozelock
Customer Services at the below address.
Disposal
Do not dispose of electrical appliances as
unsorted municipal waste, use separate
collection facilities.
Contact your local government for information
regarding the collection systems available. If
electrical appliances are disposed of in landfills
or dumps, hazardous substances can leak into
the groundwater and get into the food chain,
damaging your health and well-being.
2 Year Guarantee
This product has a 2-years warranty against
any material or manufacturing defect, from the
date of purchase of the device by the user, upon
presentation of the purchase invoice or cashier
receipt only. This warranty consists in repairing
the faulty device. Our warranty excludes:
- unauthorized disassembly of the device,
- wear parts,
- modified equipment,
- equipment used against the recommendations
described in these instructions,
- equipment abused,
- degradations due to careless use: shock, drop...
Our warranty does not cover accidents resulting
from the damage or faulty and abnormal use of
the equipment.
The legal warranty for conformity defects
and redhibitory vice applies according to the
conditions of articles 1641 to 1649 of the French
Civil Code.
Troubleshooting
Incidents Causes
The device No power
does not supply.
heat up.
The switch
(4) is not
in the
heating
position.
The plant The device
does not is not
wilt. held close
enough to
the weed.
The
application
time is
not long
enough.
For any other issues, please call our Customer
Services department. See contact Paragraph.
Solutions
Check that the plug is
properly inserted into
the socket.
Check the fuse.
Set the switch
(Fig.2 item B) to the
'heating' position.
Apply the nozzle
properly to the weed
while letting it rest on
the ground.
The application time
of the nozzle on the
weed may take longer
than 3 seconds.
If necessary, repeat
the application.