Dvb-t2/dvb-t tunercompatible with bmw professional navigation systems. (16 pages)
Summary of Contents for Caraudio-Systems DVB-MFD2-R1
Page 1
All manuals and user guides at all-guides.com dvbLOGiC DVB-T Tuner DVB-MFD2-R1 DVB-MFD3-R1 Compatible with navigation systems Volkswagen MFD2/RNS2,RNS510,RNS810 Skoda Nexus,Columbus Seat Trinax Only for vehicles WITH factory rear-view camera WITH camera control-box Product features • full plug and play vehicle-specific dual DVB-T Tuner •...
All manuals and user guides at all-guides.com Contents 1. Prior to Installation 1.1. Delivery contents 1.2. Check compatibility of vehicle and accessories 1.3. Setting the dip switches of the CAN-box TV-400/403/500 1.4. Setting the dip switches of the tuner-box DVBC-M400/403 1.4.1.
HW_____ SW_____ 2pcs antenna ANT-12 The DVB-MFD2-R1 package contains the tuner-box M400 and the CAN-box TV-400/500. The DVB-MFD3-R1 package contains the tuner-box M403 and the CAN-box TV-403/500. If remote function for a peripheral device shall be used, additional an IR- remote cable and Y-adapter are needed, see chapter AV-source.
All manuals and user guides at all-guides.com 1.2. Check compatibility of vehicle and accessories Requirements Vehicle Volkswagen, Seat and Skoda With factory rear-view camera with camera control box Navigation MFD2/RNS2, RNS510, RNS810, Trinax, Nexus or Columbus navigation Limitations Factory-TV-tuner Must NOT be installed. Teletext Teletext of the dvbLOGiC can only be used with the optionally available DVB-IRSET remote control set.
All manuals and user guides at all-guides.com 1.4. Setting the dip switches of the tuner-box DVBC-M400/403 The default dip switch settings of the tuner-box need to be changed ONLY if the AV of the dvbLOGiC shall be deactivated. The dip switches are located inside the tuner-box.
All manuals and user guides at all-guides.com 3. Installation Switch off ignition and disconnect the vehicle’s battery! If according to factory rules disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead.
All manuals and user guides at all-guides.com 3.1. Interconnecting tuner-box, CAN-box and harnesses Plug harness C3C-AV into 6pin Molex of tuner-box DVBC-M400/403. Plug harness C2C-VWR into 8pin Molex of CAN-box TV-400/403/500. Plug harness C2C-VWR into 14pin Molex of tuner-box DVBC-M400/403. Plug female 18pin AMP-connector of C2C-VWR into male 18pin AMP-socket of tuner-box DVBC-M400/403.
Page 9
All manuals and user guides at all-guides.com 3.2. Connections to head-unit and camera control-box Remove the head-unit from the dash-board and locate the camera control-box which is depending on the vehicle located either underneath the passenger seat, underneath the center console or above the wheel case of the rear right or left tire (e.g. T5 underneath the passenger seat, Tiguan rear right, Alhambra rear left).
All manuals and user guides at all-guides.com 3.3. Antennas and optional IR-remote control set Mount antennas ANT-12 and connect them to the female f-plug connectors on front of tuner-box DVBC-M400/403. We strongly recommend to first test the reception quality of the chosen mounting position of the antennas before final installation! See “Appendix C –...
All manuals and user guides at all-guides.com 3.4.1. AV-source The dvbLOGiC has the possibility to connect and remotely control by navigation buttons a pre-programmed device. The device list in the device control table (appendix A) shows the pre-programmed remote channels and the related IR-remote cables STA-xxx which must be ordered separately for the control of the device.
All manuals and user guides at all-guides.com 3.4.3. After-market rear-seat-entertainment Using RCA-cables, connect the rear-seat-entertainment to the female RCA-connector VIDEO OUT of tuner-box DVBC-M400/403. Note: As the output is a full output, not shared with the video signal for the navigation system, splitting the video with an RCA Y-cable might give a good enough picture for two rear-seat-entertainment monitors.
All manuals and user guides at all-guides.com 4.2. Selecting the dvbLOGiC as current AV-source Push the MEDIA button of the head-unit and then select VIDEO to choose the dvbLOGiC as current AV-source. 4.3. Switching between internal DVB-T and AV-input After selecting the dvbLOGiC as current AV source, tap on the touch-screen to receive the options menu.
All manuals and user guides at all-guides.com 4.5.1. Previous/next channel/track To skip to previous or next channel (TV-mode) or track (DVD/USB/iPod®-modes), use the arrow buttons in the upper left corner of the head-unit, the arrow touch-screen buttons or the UP and DOWN buttons of the steering-wheel.
All manuals and user guides at all-guides.com 5. Operation MFD2/RNS2/Nexus 5.1. Activation of the video-in-motion function The video-in-motion function is activated permanently without disturbing the navigation performance. 5.2. Selecting the dvbLOGiC as current AV-source CD-Version - Push AUX button of head-unit , then select TV to choose the dvbLOGiC as current AV-source.
All manuals and user guides at all-guides.com 5.5. Button assignment table The button assignment table shows which functions of dvbLOGiC and additionally connected devices can be executed by head-unit buttons. Once DVB-T or AV-input mode is activated, the head-unit button in the left column will execute the function described in the corresponding device column.
-30°C to +80°C Weight 328g Measurements (box only) B x H x T 140 x 30 x 105 mm 7. Technical Support Caraudio-Systems Vertriebs GmbH manufacturer/distribution In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim email support@caraudio-systems.de Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ®...
Need help?
Do you have a question about the DVB-MFD2-R1 and is the answer not in the manual?
Questions and answers