Ecosoft Titanium Gold 250 Quick Start Up Manual

QUICK START-UP GUIDE
FOR ECOSOFT TITANIUM
WATER SOFTENERS
Ecosoft has already taken care of all the essential settings for
their water softeners. All you need to do now is follow a few
simple steps.
After installing and powering up an Ecosoft Titanium system, set display
language, water hardness, current time, and regeneration options in the
Installer menu of control valve.
Use ▲ and ▼ buttons to change setting; «NEXT» button to save and go to
next step; «CLOCK» to save and exit menu; «REGEN» to move back one step.
To proceed, hold «NEXT» and ▲ buttons simultaneously for 3 seconds.
STEP 1. Language menu will show up. Select display language (English,
German, French, Ukrainian)
PPM, dH° or meq/l, using ▼ or ▲ . Press «NEXT» to go to Step 4I. Press
STEP 2. Hardness: Set the amount of hardness as calcium carbonate per
«REGEN» to exit Installer Display Settings.
STEP 3. Set Day Override (maximum number of days in service, after
which control valve will carry out preventive regeneration). 10 days is
recommended. If the water is of poor quality, we recommend regeneration
more often (7 days between regenerations).
STEP 4. Set the preferred time of delayed regeneration, hours then minutes
(factory set to 2 AM). Any time when water is not used can be set.
STEP 5. Choose whether to Turn off display backlight 5 minutes after last
keypad input event (only accessible in CE valves). Pressing «NEXT» will exit
the menu.
STEP 6. Enter current time setting by pressing CLOCK.
STEP 7. Set current time, hours then minutes.
Regen
Download the full version of the manual,
After programming the control valve:
STEP 8. Рour salt into the salt tank of the system
to the level of 1/2 to 2/3 of the tank volume.
STEP 9. Open the water supply to the softener.
STEP 10. After that, it will start the forced regeneration of thesystem
by pressing the REGEN button for 5 seconds. This is necessary for
cleaning the material from impurities and for its stratification.
click here
NORMAL MODE
NORMAL MODE