Subscribe to Our Youtube Channel
Related Manuals for Citysports CS-WP6
Summary of Contents for Citysports CS-WP6
- Page 1 Product Instruction Fitness walker Model：CS-WP6 Please read the instruction carefully before using...
-
Page 2: Table Of Contents
Content 1．Security cautions..............1 2． Quality Assurance Commitment.........2 3．Configuration list and technical parameters......2 4．Product parts................3 5．Assembly instructions............3 6．Functional operation instructions..........5 7．Warm-up exercise..............6 8．Maintenance Guidelines............8 9．Fault code................8... -
Page 3: 1．Security Cautions
Thank you for purchasing our product, our products will help to improve your health. Security cautions In order to ensure your safety and avoid accidents, please read the instructions carefully before use. This product is indoor use only, please do not make it or use it outdoors; the treadmill should be ... -
Page 4: 3．Configuration List And Technical Parameters
Use non-original accessories. Privately handled incorrectly. Not follow the instructions. This pledge is valid only for private use by families and is not applicable to professional training such as gyms. If you need to buy non-warranty accessories, please contact customer service. Please provide the following information when ordering: Instructions. -
Page 5: 4．Product Parts
Product parts Bluetooth speaker Display panel Motor cover Running belt Foot pedal Motorlower cover Backcorner right Back corner left Power switch 5. Assembly instructions Assembly steps Out of the box, take out the accessories and the machine from the box, and put the machine on a flat ground, connect it to the power and use it. -
Page 6: Display Panel
Display Panel Start / Sotp key Function display: speed, calories, time, distance. Speed down Speed up Infrared receiver Infrared receiver: Please point the remote to this area when using the remote controller. Display screen: SPEED will display when adjusting speed; SPEED/CAL/TIME/DIST. Will be displayed in loop by 3 seconds interval. -
Page 7: 7．Warm-Up Exercise
Remote control instructions： Key: When the host is in standby mode, press key and the machine will run from a low speed of 0.6 mile, then press key to stop the machine. (Ie start/stop function loop) + Key: Each time you press the + key during operation, the speed will increase by 0.2 mph; long press the + key to continuously increase the speed at 0.2 mph. - Page 8 1. Stretch downward: Bend your knees slightly and bend your body forward slowly. Relax your back and shoulders and touch your toes with both hands. Hold for 10 to 15 seconds, then relax. Repeat three Figure 1 times. Figure1 2. Stretch your ankles: Sit on a clean cushion and straighten one leg.
- Page 9 1. Adjusting the Running Belt If you are using a walking machine, you can adjust the belt tightness to improve the slippage or non-fluidity of the running belt. Adjusting running has two functions: tightening adjustment and belt center position adjustment. Running belt has been adjusted when it is out of the factory, but after use, the running belt will be stretched, which will deviate from the center position and cause the running belt to rub the foot sidebars and rear cover damage.
- Page 10 Note: When you use a walking machine, the pressure on the running belt is not balanced due to the difference in the force used by the two feet when running, causing the running belt to deviate from the center. This kind of deviation is normal. When no one is running on the running belt, it will return to the center.
- Page 11 to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the CS-WP6 and is the answer not in the manual?
Questions and answers