Download Print this page

DGS -WS8'L Instruction Manual

Workstation

Download this manual

DGS Workstation

SKU: DGS-WS8'L

Recommended Tools:

 Compact Drill/Driver

 T-25 Star Drive Bit

 Rubber Mallet

 Wood Glue

Part Number

CUSTOM

8' Workstation Side Rails

CUSTOM

32.5" Workstation Rungs

CUSTOM

Workstation Backer Boards

PTN3S5

3" Wood Screws

Part Description

Instruction Manual

DGS Workstation

Quantity

Need help?

Call 1-800-932-3339 or

Email info@gymsupply.com

Need help?

Do you have a question about the DGS-WS8'L and is the answer not in the manual?

Page 1 Instruction Manual DGS Workstation DGS Workstation SKU: DGS-WS8’L Recommended Tools:  Compact Drill/Driver  T-25 Star Drive Bit  Rubber Mallet  Wood Glue Part Number Part Description Quantity CUSTOM 8’ Workstation Side Rails Need help? CUSTOM 32.5” Workstation Rungs...
Page 2 Instruction Manual DGS Workstation Step 1: Lay out the 8’ Workstation Side Rails parallel to each other, leaving approximately 3ft of space between them. Place all Workstation Rungs between the side rails, aligning them with the corresponding holes. IMPORTANT: It is strongly advised to use Wood Glue for securing the Rungs.
Page 3 34” 96” Step 4: Your DGS Workstation is now prepared for wall mounting. Consider the type of wall you are using for installation and secure it with the appropriate anchors. Attach the Workstation to the wall by using 3” Wood Screws through the Backer Boards.