Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for LuxaFlex Kalmar
Summary of Contents for LuxaFlex Kalmar
- Page 1 Installation manual Awning Kalmar...
-
Page 2: Icon Overview
If any irregularities are observed during opening and/or closing, call a professional installer. To avoid possible damage, do not allow children to play with the awning. Luxaflex installation manual - Kalmar ®... -
Page 3: Product Parts
Product parts 1. Split view - parts list Wall mounting (option) Front bar Base box Front bar cover Descrip�on: Cover rail Wall mounting (option) 11 Front bar cover Base box 12 Leg Cover rail 13 Guide rail Side cover Guide rail 4 Side cover 14 Inlay Motor mounting... - Page 4 Don't do the work by yourself, remember to use a level during installation. Picture 1. Mounting elements - spacing plates, wall mounting. www.sunshade-experts.com *uwaga! do montażu należy użyć kotew odpowiednich dla podłoża (ściana ceglana, betonowa itp.) i o odpowiedniej nośności Luxaflex installation manual - Kalmar ®...
-
Page 5: Installation Instructions
the elements are on the same level and the holes are in axis (Pic. .). The distance between the mounting elements depends on the width of the product (Pic. .). CAUTION! Risk of the awning falling, the order of assembly must be observed! Evaluate the Installation instructions conditions on location and use the appropriate xings. - Page 6 Min 120 Drop the box and hook it to the wall plate (1), then slide in the lower part of the mount (2) finally slide in the mount locks and tighten the screw (3). Luxaflex installation manual - Kalmar ®...
- Page 7 Distance between wall elements. 4. Slide in the guide rails and position the legs Connect the power supply and by using the remote control, move the fabric out slightly (Pic. 8.). Next secure end slat to prevent its falling. Then insert and screw the legs slightly into the guide rail so that they can be operated. Slide the guides into the side with a minimum of 2 people, make sure there is a line in the middle of the guide rail (Pic 9), guide the zip from the fabric into the inlay while sliding.
- Page 8 Position brackets on the construction and mark the places where the hole will be drilled. Support - Height of brackets 73 - 150 mm - Standard 120 mm - Minimum total height 120 mm - Minimum total height Kalmar larger than standard 400 x 400 cm - 120 mm 50,5 max 3150 mm...
- Page 9 Regulation must be done very carefully. Difference between dimensions cannot exceed 5 mm! It is important to check the dimension between guide rails by the box and at the plugs of the side guide rail - dimensions have to be identical. Not following the rules during installation may cause damage to the product and invalidate the warranty.
- Page 10 After correct installation, perform a test run, check the fabric tension, check the lines in the guide rail for tension and correct operation (if they did not fall off the guide wheels). Luxaflex installation manual - Kalmar ®...
- Page 11 Check if the fabric zips are guided in the inlay.
- Page 12 Remove the front slat flap and check that springs and components are in the right place. Check if the springs have the correct length. Maximum length Free length Free spring Maximum Kind of spring length (cm) length (cm) Long Short Check if connecting elements are not loose. Luxaflex installation manual - Kalmar ®...
- Page 13 Check the diagonals and the lengths between the guide rails at the end and start points. V1 = V2 L1 = L2 Check guiding of the line on all wheels. Check guiding of the line on all wheels. Check if fabric zip is guided in Inlay Check if fabric zip is guided in Inlay.
-
Page 14: Information To The User
If the product becomes wet in heavy rain, it can still be rolled up and unrolled later to dry. However, it is important to avoid leaving the rolled-up wet fabric for more than three days to prevent the formation of mould or stains. Max. 3 days Luxaflex installation manual - Kalmar ®... -
Page 15: Cleaning Instructions
Cleaning instructions Before cleaning, remove loose dirt. Then, using warm water (max. 30°), remove any remaining dirt. For deeper stains, use water with a small amount of soap. Always rinse the fabric thoroughly after cleaning. Avoid cleaning in direct sunlight as soapy water dries quickly and may leave stains on the fabric. - Page 16 WARNING! Keep the remote control and transmitter out of the reach of children. This product is not suitable for children’s play. Only steer the product when it is within your field of vision. Remember to have an annual service performed by a professional installer. Luxaflex installation manual - Kalmar ®...
- Page 17 Product check-up Perform a test run and check if the product rolls out and retracts properly. Ensure that the fabric is properly tensioned. ATTENTION! Disconnect power before performing service check. Remove the flap in the front slat and check if the springs are in the correct position. Ensure that the springs are of the correct length.
- Page 18 Check if fabric zip is guided in Inlay Check if the fabric’s zip is inserted into the inlay. www.sunshade-experts.com *uwaga! do montażu należy użyć kotew odpowiednich dla podłoża (ściana ceglana, betonowa itp.) i o odp Luxaflex installation manual - Kalmar ®...
- Page 20 We cannot accept any responsibility for problems arising out of a failure to follow the installation and operating instructions. If you would like more information and/or you are having problems, please contact the dealer where you bought your Luxaflex product. ®...
Need help?
Do you have a question about the Kalmar and is the answer not in the manual?
Questions and answers