Shockwave S5 Corbin Seat User Manual
Mid-back seat-black/white
Hide thumbs
Also See for S5 Corbin Seat:
- User manual (20 pages) ,
- User manual (14 pages) ,
- User manual (20 pages)
Related Manuals for Shockwave S5 Corbin Seat
Summary of Contents for Shockwave S5 Corbin Seat
- Page 1 User Manual S5 Corbin Mid-back Seat – Black S5 Corbin Mid-back Seat – White SW-04920-B SW-04920-W F E E L B E T T E R . T R A V E L F A R T H E R .
-
Page 2: Customer Service
Customer Service Included with your Purchase: At Shockwave, we’ve proven that innovation and • 1 – S5 Corbin Seat – Fixed Back Seat attention to the highest safety standards can protect • 4 – 5/16 x 1-1/4” Countersunk Cap Screw boaters from the shock of wave impact. -
Page 3: Installation Instructions Overview
Pass six 1/4 x 1” fasteners through snap bases, then apply Loctite 243 and install the two Y brackets onto the backrest using the fasteners and torque to 1.1Nm [10in-lbs]. 1 – S5 Corbin Seat – Fixed Back Seat 4 – 5/16 x 1-1/4” Countersunk Screw Backrest 4 –... - Page 4 S5 Corbin Seat Installation — Marine Suspension Base S5 Corbin Seat Installation on Shockwave Swivel or Slide Bolt backrest assembly onto suspension using 5/16-1-1/4” countersunk caps screws, nylon Bolt backrest assembly onto suspension base with nylock nuts and flat washers washers, flat washers, and nylock nuts.
- Page 5 S5 Corbin Seat Installation on Shockwave Swivel S5 Corbin Seat Installation on Shockwave Slide Apply Loctite 243 to the threads of the 4 fasteners provided. Apply Loctite 243 to the threads of the 4 fasteners provided. Loosely install all fasteners with the swivel shield oriented as shown.
- Page 6 S5 Seatbelt Instructions S5 Seatbelt Instructions — continued Disassemble the backrest from the seat by removing the 6 fasteners Re-attach the backrest using the 6 fasteners, do not over tighten as it will distort the plastic located at the back of the backrest. The fasteners have a protective snap cap washers.
- Page 7 S5 Corbin Heated Seat Wiring Instructions (sold separately) S5 Corbin Heated Seat Wiring Instructions — continued Choose the location for the seat heat switch with a panel thickness of 0.105” [2.67mm] to 0.187” [4.75mm] and cut a hole to the Route the Power Harness from the switch location size shown below.
- Page 8 Marine Suspension Seats is limited to repair or replacement 12. Connect the red wire from the Power Harness to a 12 Volt DC It is agreed that Shockwave Seats shall not be liable for incidental or consequen- of defective materials or defective workmanship, after verification by Shockwave tial damages, including, but not limited to, loss of income, loss of use, lost profits, positive source.
- Page 9 @shockwaveseats www.shockwaveseats.com sales@shockwaveseats.com +1.778.426.8545 �� ✉ SQUARE-P SW-08429 REV04...
Need help?
Do you have a question about the S5 Corbin Seat and is the answer not in the manual?
Questions and answers