Table of Contents
Advertisement
Step 1: Setup your new Peregrine appliance
Perform the procedures as detailed in this Setup Guide,
Start Network
Discovery. If your new appliance will have the same IP address as
the old appliance, do not connect the new appliance to the network yet. You will
do that later in this process.
Step 2: On your old appliance, do an internal backup
Click Administration > Backup and restore > Run internal backup now.
If you cannot perform this step, you will restore data from the last time the old
appliance did an automatic internal backup (which occurs daily after midnight).
Note:
This action will also initiate an external backup if one has been
configured.
Setup Guide
Chapter 5, Install and
Restoring your data | 139
Advertisement
Table of Contents
