Insignia NS19RTR Manual page 20

4 Press the CH
channel.
If you use the number buttons to select a TV channel:
•
•
•
5 Press the VOL.
Note
Watching TV from a cable box or satellite box
To watch TV from a cable box or satellite box:
1 Use your DVD combo's controls to set the channel to the cable or
satellite access channel (usually channel 3 or 4).
2 Use the cable or satellite box to tune to a TV channel.
Watching TV from an external input device
To watch TV from an external input device:
• If your DVD combo is connected an external TV through your
DVD combo's front audio and video jacks, press the INPUT or
CH
Setting up channels
When you first set up your DVD combo, you need to set up the
channels available in your area.
To set up channels:
1 Press the SETUP button.
2 Press the
the ENTER button.
3 Press the
AUTO PRESET CH (CATV), then press the ENTER button
DVD combo scans for and stores available TV or CATV channel
numbers in your area. When the scanning is complete, the lowest
channel number found appears on the display.
Note
18
or
Press 0 and a number button for a one-digit channel
number.
Press the number buttons for a two-digit channel number.
Press the +10/+100 button, then press the last two channel
numbers for a three-digit channel number.
or
If you turn off your DVD combo in DVD mode,
when you turn it back on, your DVD combo will
be in TV/VCR mode.
or button until AUX appears on the screen
button to select CHANNEL SET UP, then press
or
button to select AUTO PRESET CH (TV) or
or
If NO TV SIGNALS appears on the screen, make sure that your
antenna is connected correctly and securely, then scan again.
You do not need to set up channels if you are connected to a cable
or satellite box. Instead, use your DVD combo's controls to set the
channel to the cable or satellite access channel (usually channel 3
or 4). Then use the cable or satellite box to tune to a TV channel.
www.insignia-products.com
NS-19RTR 19" DVD Triple Combo
button or the number buttons to select a TV
button to adjust the volume.
.
Your
.