Silverlit BUMPER PHOENIX Manual

4 ENGLISH
3. Flight control:
Hover up and down:
The throttle stick controls the drone elevation.
Push the stick forward and the drone will rise.
Pull the stick downward and the drone will descend.
Only small amounts of stick position changes are
required for smooth flying.
Forward and backward flight:
Maintain the Drone at a certain height. Push the
direction stick upward to fly the Drone forward,
and pull it downward to fly the Drone backward.
Turn left and right:
Maintain the Drone at a certain height. Push the
direction stick toward left to turn the drone counter
clockwise, and push it toward right to to turn it
clockwise.
Trouble Shooting
Symptom
The drone does not response. - The drone and/ or the transmitter is switch
off ("OFF").
- The battery of the drone is weak.
The Drone does not react, or react - PAIRING / SYNC Procedure is not yet
poorly to operation by transmitter. completed or done.
Loss of control. - Out of the control range of distance.
- Rotor blade is deformed or distorted.
Bumper Phoenix
TM
2 ENGLISH
Part Identification
Drone
Power switch
OFF
Charging
socket ON
Transmitter
Power indicator
Throttle stick
Power switch
Battery Installation & Charging
Transmitter Battery Installation (*Make sure the power switch is on "OFF" position.)
Note: When the Power indicator on the transmitter starts blinking, replace the batteries.
Charging the Drone
1. Connect the charging cable to a USB 2. Turn off the drone. Insert DC plug into the
socket. charging socket. The charging process
will begin automatically, and the charging
indicator will light up.
Note: 1. The drone can operate for about 5 minutes per every 30 - 45 minutes charging.
2. Before recharging the battery, wait 10 - 15 minutes for it to cool down.
Hover up
Hover down
Forward Backward
Cause Correction
- Set the power switch to "ON".
- Recharge the battery of the drone.
- Repeat the PAIR/SYNC procedure again.
- The transmission range is up to 30 meters in
open space.
- Replace the rotor blade with the spare one
provided.
Caution: Spare propeller
only to be replaced by an
adult.
Propeller
Impact protection rings
Direction stick
Trimmer
Battery cover
Warning!
Remove these
batteries from the
unit by pulling up
on one end of
each battery
positive by hand.
3. Unplug the charging plug when charging
indicator turns off, charging is completed.
EI-9602
BUMPER
MFR No. 84814
Delivery contents
Drone
Precautions, Warnings & Statements
The symbol showing a crossed-out rubbish bin indicates that ordinary batteries,
rechargeable batteries, button batteries, battery packs etc. should not be disposed of
with household waste. Batteries are dangerous for health and the environment. Help to
protect the environment against health risks. Ask your child to dispose of batteries
cleanly by taking them to your local collection points. In this way, batteries can be
recycled safely.
Warning: Conversion or modifications to this product not expressly approved by the party
responsible for compliance could void the user's authority to operate the product.
- Transformer or battery charger used with the toy are to be regularly examined for damage to
the cord, plug, enclosure and other parts, and in the event of such damage, they must not be
used until the damage has been repaired.
Care and Maintenance:
- Always remove batteries from the product when it is not being used for a long period of time.
(Transmitter only)
- Wipe the product gently with a clean damp cloth.
- Keep the product away from direct heat.
- Do not submerge the product into water that can damage the electronic assemblies.
Special notes:
- Caution. Read the manual carefully before first use.
Notes:
- New alkaline batteries are recommended to use in this product to obtain best and maximum
performance.
- This product must only be used with the recommended charger.
Battery warnings:
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed before being charged. (Transmitter only)
- Rechargeable batteries should be charged under adult supervision.
- Different types of batteries or new and used batteries are not to be mixed. (Transmitter only)
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with correct polarity. (+ and –)
- Exhausted batteries are to be removed from the product. (Transmitter only)
- The supply terminals are not to be short-circuited.
- Do not mix old and new batteries. (Transmitter only)
- Do not mix alkaline batteries, standard batteries (carbon-zinc) and rechargeable batteries
(nickel-cadmium). (Transmitter only)
This Drone is equipped with a LiPo rechargeable battery, please pay
attention to the following cautions for safety use:
- Do not dispose the battery in fire or heat.
- Do not use or leave the battery near a heat source such as fire or heater.
- Do not strike or throw the battery against hard surface.
- Do not immerse the battery in water, and keep the battery in a cool dry environment.
- When recharging, only use the battery charger specifically for that purpose.
- Do not over-discharge the battery.
- Do not connect the battery to an electrical outlet.
- Do not directly solder the battery and pierce the battery with a nail or other sharp object.
- Do not disassemble or alter the battery.
- Charge the battery every 6 months.
- This toy (drone) contains battery that is non-replaceable
Battery requirement for Transmitter:
Power Supply :
Rating : DC 3 V , 0,15 W
Batteries : 2 x 1.5 V "AAA"/LR03/AM4 (not included)
Flying the Drone
Tip! CONTROLLING
- For controlling the sticks on transmitter, try not to push the sticks immediately to any extreme positions. It should be like steering a bicycle rather than
pressing computer game sticks.
- For the novice pilot (after the trimming procedure is completed), it is highly recommended to focus exclusively on learning to control the left stick first. If
the Drone turns around by itself there is no need to keep it straight. For the first flight, it is important to learn to keep the Drone at a constant left of
around 1 meter with very gentle inputs on the left stick. Once the pilot masters this, he may start learning to take control with the right stick.
1. Procedure for PAIR / SYNC the Drone and Transmitter
2.4 GHz technology allows for many Drone to fly without signal interference. A connection, PAIR
/ SYNC, must be made between the Drone and the transmitter to function. Follow these steps to
PAIR/SYNC the Drone and the transmitter.
- Turn the Power Switch button to "ON" position on the Drone, the LED will gradually fade in and
out.
- Place the drone on the ground with the tail point towards you and the nose pointing away.
- Switch on the transmitter.
- When the power indicator become flash. Push the throttle stick to top then pull down to bottom.
The pair procedure is completed when the power indicator is light up. (Fig 1)
2. Trimming the Drone
- Gently push the throttle up to raise your drone about 0.5 to 1 meter high.
Keep going left
- When your drone keeps rolling sideways to left, press right
side of the Trimmer continually until it stops rolling.
DO NOT remove
or install batteries
using sharp or
metal tools.
Keep going left
Rotate Trim
Vertical press the direction stick once, the Power indicator will flash
to indicate it entered to rotate trim mode. Press again it will switch
back to side fly trim mode.
Note: If no any input for awhile it will automatically go
back to side fly trim (defalut).
Keep spiral or turning counter clockwise
- When your Drone keeps spiral or turning counter clockwise,
press right side of the Trimmer continually until it stops turning.
Spiral or turning counter clockwise
PHOENIX
Hereby, Silverlit Toys Manufactory Ltd declares that the radio equipment
84814 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
This toy is only to be connected
internet address: www.silverlit.com/a/certificate
to equipment bearing either of
the following symbols:
OR
Frequency Band Range: 2400 - 2483.5MHz Maximum Radio-Frequency Power:＜10dBm
Transmitter
Charging Cable Spare Rotors
WEEE
When this appliance is out of use, please remove all batteries and dispose of them
separately. Bring electrical appliances to the local collecting points for waste electrical
and electronic equipment. Other components can be disposed of in domestic refuse.
FCC Statements
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1)This device may not cause harmful interference, and
2)This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Tip! Safety hints
- Never take apart or attempt to modify the product. This could damage the product.
- Drone piloting requires specific skills and should be learned under direct supervision of an
experienced adult.
- Never operate this product if it has damaged parts.
- Attention! Do not fly the Drone near persons and animals.
- Do not fly the Drone in the vicinity of water and power lines.
- Always keep your eyes on the Drone and prevent it from landing or crashing near your head, your
body, or on other people.
- Stand during operation in order to get out of the way of the Drone quickly if necessary.
- Always switch the Drone and the transmitter off when not operating.
- Warning! Do not touch the running rotors. Keep hands, hair and loose clothes away from moving
parts to avoid injury.
- Never hold or throw any objects into the running rotors.
- Attention! Risk of eye injuries! Keep a safety distance of at least 1 meter.
- Instruction sheet and packaging must be retained since it contains important information.
The normal function of the product may be disturbed by Strong Electro
Magnetic Interference. If so, simply reset the product to resume normal
operation by following the instruction manual.
In case the function could not resume, please use the product in other
location.
Battery requirement for Drone:
Power Supply :
Rating
Batteries
Capacity
Silverlit SAS, 80 rue Barthelemy Danjou, 92100 Boulogne-Billancourt / France.
©2022 Silverlit. All rights reserved.
Keep going right
- When your drone keeps rolling sideways to right, press left
side of the Trimmer continually until it stops rolling.
Keep going right
Keep spiral or turning clockwise
- When your Drone keeps spiral or turning clockwise, press left
side of the Trimmer continually until it stops turning.
Spiral or turning clockwise
ENGLISH 1
Tool for Rotor
Replacement Instructions manual
: DC 3.7 V , 10 W
: 1 x 3.7 V LiPo Rechargeable Battery Pack (included)
: 350 mAh
ENGLISH 3
1
2
Fig 1