Installing The Drive In The Nec Versabay Iv Slot - NEC VERSABAY IV DRIVE Manual

Installing the Drive in the NEC VersaBay IV Slot

Use the following steps to install your new VersaBay IV device in the VersaBay IV slot.
If you need to remove a device from the VersaBay IV slot, see "Removing a Device from
1.
the VersaBay IV Slot," earlier in this document.
For information on hot swapping or warm swapping devices, see the information about the
Phoenix BaySwap utility in your printed user's guide.
Locate the NEC VersaBay IV release latch to the right of the VersaBay IV slot.
2.
Flip the latch to the open position.
3.
Align the drive in the NEC VersaBay IV slot and push it in until it fits securely into the bay.
4.
Press the latch back to the locked position.
5.
Press the Power button to power on or resume operation.
6.
Inserting an NEC VersaBay IV drive
NEC VersaBay IV Drive 3