Emergency Eject Hole — allows you to manually remove a disc from the drive if the eject
!
function is disabled by software or a power failure.
To remove a disc, insert the end of a paper clip into the eject hole, and push in until you
hear a click. Manually open the drawer.
Disc Eject Button — ejects the CD tray. Press this button when power is on to insert a CD
!
into or remove a CD from the drive.
Status LED — lights during data read operations. Do not eject the CD or turn off the NEC
!
Versa notebook when the indicator is lit.
Removing a Device from the VersaBay IV Slot
Before installing your new NEC VersaBay IV drive, remove any device or the weight-saving
module (if in place) from the VersaBay IV slot as follows.
If a VersaBay IV device is in the slot, use the Phoenix
1.
system. (See your printed user's guide for information about the Phoenix BaySwap utility.)
If a VersaBay IV weight-saving module is in the VersaBay IV slot, skip to step 2.
connected to an AC power source, verify that the primary battery is not in a low-power state. If it
is, plug in the system before removing the VersaBay IV battery.
Locate the NEC VersaBay IV release latch to the right of the VersaBay IV slot.
2.
Flip the latch to the open position. Then press the latch into the system to eject the device.
3.
Pull the device out of the system.
4.
don't install a VersaBay IV device. The weight-saving module shipped with your system.
2 NEC VersaBay IV Drive
If you plan to hot swap a VersaBay IV battery and the system is not
Removing a device from the VersaBay IV slot
Always install the weight-saving module in the VersaBay IV slot if you
®
BaySwap™ utility or power off the