unios Pandia Manual

Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this luminaire. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This luminaire will not be used as a
'Working light' during construction. This will result in the warranty of the luminaire to be void. For warranty duration,
please refer to the data sheet.
Cleaning
Always clean carefully using a soft cloth and a ph-neutral,
alcohol-free, non-abrasive cleaning cloth. Clean & Maintain
the finish twice a year to avoid rust, oxidation or limescale
deposits. If this entire surface is not cleaned correctly, the
finish may become uneven.
Do not use abrasive pads, discs, sandpaper and/or high
pressure hose/gun to clean the luminaire.
Edition 24.9.24 | Product design and technical data may be subject to change
Page 4 of 4
unios.com/pandia
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment)
Pandia
Base Small Medium
Codes
PANW0130 PANW0250
Class I Material Operating Temp
Aluminium <35°C
220–240V ~ 50/60Hz
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Front View
A
Side View
B
C
Edition 24.9.24 | Product design and technical data may be subject to change
Page 1 of4
unios.com/pandia
WALL LIGHT
IP65
Install Person/s Power
1x 4-9 Watts
Sizing Variations
Product Code A B
PANW0130 Ø 130 63
PANW0250 Ø 250 63 Ø 100
All measurements are in millimetres.
Parts
2x 4x
OR OR
2mm Hex M4x25 Plug & Screw M4x25 Plug & Screw
Allen Key
PANW0130 PANW0250
3x 2x
OR OR
Heatshrink Glove Gloves
Solder Joiners
PANW0130 PANW0250
Gloves Recommended
To avoid leaving marks and finger prints, gloves are
recommended for the installation of the Pandia Wall Light.
C
Ø 72