Contents at the device itself. ● Do not spray any objects which contain harmful substances (e.g. asbestos). ● Check Safety instructions ..........the device and the accessories, such as the high-pres- Safety devices ............. sure hose, high-pressure gun and safety devices, to Symbols on the device ........
tension cable by running over it, crushing or yanking it Power switch or similar. Protect the power supply cable from heat, oil The power switch prevents unintentional operation of and sharp edges. ● Unsuitable electrical extension ca- the device. bles are dangerous. Only use approved and appropri- Trigger lock ately marked electrical extension cables with a sufficient line cross section when outdoors: 1-10 m : 1.5 mm...
Installation Notes on the content materials (REACH) Current information on content materials can be found For the illustrations, refer to the graphics page. at: www.kaercher.de/REACH Fit the supplied loose parts onto the device before start- Accessories and spare parts ing up the device. Have the included screws and the appropriate screw- Only use original accessories and original spare parts.
Note 4. Turn the power switch to the “I/ON” position. Kärcher recommends the use of an optional Kärcher The device is switched on. water filter. 5. Unlock the trigger, see Trigger lock. 6. Pull the trigger and carry out the cleaning process. Connection to the water line Operation with detergents ATTENTION...
1. Lock the trigger, see Trigger lock. 4. Store the spray lance with the jet nozzle and the 2. Empty the detergent out of the detergent tank. high-pressure gun on the accessory holder. 3. Rinse the detergent tank with clear water. Illustration R 4.
Warranty Cleaning the jet nozzle 1. Remove the jet nozzle from the spray lance, see The warranty conditions issued by our relevant sales High-pressure operation. company apply in all countries. We shall remedy possi- 2. Insert the cleaning needle into the jet nozzle and ble malfunctions on your appliance within the warranty loosen the dirt.
Need help?
Do you have a question about the K 1 Upright and is the answer not in the manual?
Questions and answers