Table of Contents
Advertisement
Page 1
Orientation
Set the projection method. Use the
buttons to select
Front Floor, Rear Ceiling, Rear Floor or Front Ceiling.
Background
Select the background when there is no signal. Use the
buttons to select Blue, Black, or Logo.
Signal Select
RGB:Normally select "Auto". RGB and component signals are
switched automatically. If the signal does not switch when
component signals are input, select the "Component".
Video & S-Video:Set the video mode. When "Auto" is
selected, NTSC 3.58, NTSC 4.43, PAL, PAL 60 or SECAM is
selected automatically.
(NTSC 4.43 and PAL 60 are not identified automatically when
the LT series projector is used. To view in one of these
modes, select the mode from the pull-down menu.)
previous page
next page
Advertisement
Table of Contents
