FXONE Model: FX729U SAFETY CAUTIONS • Original instructions. Read these safety precautions carefully before using the unit! This appliance should only be used as described within this instruction booklet. Please retain for future reference. IMPORTANT CHILD SAFETY • ALWAYS keep out of the reach of very young children (during and after use).
Page 4
• Outside the UK: If using the appliance in a bathroom, unplug after use as the proximity of water can be dangerous even if the appliance is switched off. For additional protection the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom.
Page 5
there is a detachable power supply for means of charging. • Do not leave the appliance unattended when switched • Do not leave the appliance plugged in for more than 24 hours. • Unplug immediately if any problems occur during use. •...
Page 6
certified company that continually evaluates our Quality Management System performance. If you have any queries regarding product safety and compliance, please contact the Conair Customer Care Line (refer to ‘UK After Sales Service’ section). WEEE - END-OF-LIFE ELECTRICAL AND ELECTRONIC EQUIPMENTS In everybody’s interest and to actively participate in protecting the environment and human health:...
TECHNICAL DATA USB-C adaptor CA88M adaptor CA78M Vibrations < 2.5 m/s² LpA (dB(A)) < 70 ON/OFF SWITCH To operate, simply slide switch to «I» position. To stop operation, set to the «0» position. Make sure the switch is in the OFF (“0”) position when the trimmer is not being used.
BLADE CARE Because the trimmer blades are precision-made they should always be handled with care and cleaned regularly to ensure maximum per- formance. Each time you finish using the trimmer, take the cleaning brush provided and brush away any loose hair that has collected in the blades.
Page 9
ZERO GAP ADJUSTMENT TOOL IMPORTANT! Only attempt to zero gap the blades by using the adjustment tool and following the instructions very precisely. The adjustment tool is required to adjust the blades to zero gap, which will achieve a closer, more precise cut. •...
Page 10
• Step 5 – Once the blade is adjusted to zero gap or your liking, gently tighten the two screws on BATTERY REMOVAL AND INSTALLATION The FX729U trimmer features a removable, rechargeable, and interchangeable battery, so you can cut and style for extended amounts of time with minimal interruption.
Plug charging stand into outlet to charge batteries. To disconnect, first remove batteries from charging stand, then unplug from outlet. Use of a charging stand not sold by BaBylissPRO may result in risk of fire, electric shock, or injury to person.
Page 12
Keep away from children. Failure to comply with these warnings could result in fire or serious injury. This trimmer is intended for trimming purposes only. This product is for commercial use. CHARGING STAND INSTRUCTIONS The FXONE Universal Battery Charging Stand can be powered by either the universal FXCORD (not included) or a USB-C adaptor.
BATTERY/CHARGING INDICATOR (TOP OF FXONE BATTERY) Blue flashing – Charging Blue solid – Charged (see charge levels below) • The charging stand may become warm while charging. This is normal. • Preserving the battery: In order to maintain the optimum capacity of the rechargeable battery, it should be recharged for 3 hours approximately every 6 months.
Page 14
Read these instructions carefully before connecting the charging stand to any power supply. OPERATION 1. For dry use only. Do not expose to water. 2. When not in use, unplug unit completely. 3. Unit will become warm during operation. TRIMMER OPERATING PRECAUTIONS This trimmer has a removable rechargeable battery.
Page 15
products etc. Please contact the Conair Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday) or e-mail ukinfo@conair.com for further information on authorised stockists. It is important to retain your proof of purchase. We recommend attaching your receipt to this page. Even where a refund may be applicable, no refund will be provided without a valid receipt or proof of purchase, we will only be able to offer a repair or replacement service.
UK AFTER SALES SERVICE For further advice on using the appliance or should you need to return your product, please contact the Conair Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday) or e-mail your enquiry to ukinfo@conair.com.
Page 17
: Trimmer Type number : T182a Trademark : BaBylissPRO / Conair / CPL With following characteristics : Unit : 3.6VDC, 8.71Wh (2.42Ah) / 3.6VDC, 11.88Wh (3.3Ah) Charging stand: 4.5VDC, 1.2A, 5.4W / 5.0VDC, 2.0A, 10.0W Adaptor : 100-240V~, 50-60Hz, 4.5VDC, 1.2A, 5.4W / 5.0VDC, 2.0A, 10.0W...
Need help?
Do you have a question about the FXONE LO-PRO and is the answer not in the manual?
Questions and answers