Download Print this page

Advertisement

Quick Links

安装说明书
K-72866T-CP
K-72867T-CP
安装之前
所有的资料是按最新出版的产品资料编写而成。
科勒公司保留任何时候不经通知即可改变产品特
性、包装或产品可供类型的权利。
说明书包括重要的安装、保养及清洁方面的内容,
请把这些资料交给用户阅读。
注意事项
1. 一定要先彻底冲洗供水管以清除管道中的杂
质,使用水源为自来水或可供饮用水。
2.请勿将强大的冲击力施于产品,以免造成损
害,引起故障。
3.安装、清洁龙头时,切勿损伤感应窗口表面,
以免造成故障。
4.如果是安装新的洗面盆,可将水龙头和排水
组件先安装好到面盆上。
5. 对于直流龙头, 安装时注意电池的正负极不
能装反,电池盒盖要拧紧,防止电池受潮。
6. 对于交流龙头,安装时务必按照说明书的要
求正确连接导线,龙头安装完毕后才可向电源盒
供电。
7. 一个交流电源盒最多可供两个感应龙头。
8. 交流电的总电源必须有合适熔断丝加以保护。
9. 请勿使产品感应窗口靠近强紫外线或电磁场。
10. 修理面盆时,用黑色电工胶布粘住感应窗口。
11.维修交流龙头时,必须断开交流电源并关闭
水源。
1246885-T01-C
Strayt Sensor Faucet - Cold Only /AC w/o power unit
斯磊台盆感应龙头-交流电/单冷型/不含交流电源盒
Strayt Sensor Faucet - Cold Only (DC)
斯磊台盆感应龙头-直流电/单冷型
科勒(中国)投资有限公司
中国上海市静安区江场三路158号 邮编:200436
制造商:上海科勒电子科技有限公司
中国上海宝山区丰翔路1955号 邮编:200444
BEFORE YOU BEGIN
All information is based on the latest product information
available at the time of publication, Kohler Co. reserves the
right to make changes to product characteristics,
packaging, or availability at any time without notice. Please
leave these instructions for the consumer. They contain
important installation, maintenance and cleaning
information.
Notes:
1. Flush the water supply pipes thoroughly to remove debris.
Faucet is designed for tap water or potable water.
2. Handle the faucet with care to avoid damage.
3. Do not damage the surface of sensing window when
installing or cleaning the faucet.
4. For new installations, install the faucet and drain onto
the lavatory before installing the lavatory.
5. As for DC type faucets, please pay special attention to the
battery poles direction. Tighten the battery cover completely
to prevent its exposure to moisture.
6. For electric connection on AC faucets, carefully follow the
installation provided. Only provide electric supply to the
power box after the installation is completed.
7. Only install a maximum of two faucets to one AC/DC
transformer.
8. Ensure electrical source is fitted with a suitable fuse to
protect AC/DC transformer unit from damage.
9. Do not put the faucet near strong ultraviolet or
electromagnetic field.
10. Cover the sensing window with black tape when
repairing lavatories.
11.Turn off the electrical source and shut down the water
supply before servicing faucet.
1
斯磊
STRAYT
TM
2014
2014

Advertisement

loading
Need help?

Need help?

Do you have a question about the STRAYT K-72866T-CP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kohler STRAYT K-72866T-CP

  • Page 1 BEFORE YOU BEGIN 安装之前 All information is based on the latest product information 所有的资料是按最新出版的产品资料编写而成。 available at the time of publication, Kohler Co. reserves the 科勒公司保留任何时候不经通知即可改变产品特 right to make changes to product characteristics, 性、包装或产品可供类型的权利。 packaging, or availability at any time without notice. Please leave these instructions for the consumer.
  • Page 2 OPERATING INSTRUCTIONS 使用说明 Place your hands under the faucet within the 手伸到出水口下方感应范围内 sensor range (the sensor range will auto- (感应距离随面盆、周围的情况 adjust to its surroundings, the faucet should 而自动调节),水龙头出水。手 be on. The faucet will automatically turn off 离开后0.5~1秒,水龙头自动止 after 0.5~1 second after moving your hands 水。...
  • Page 3: Rough-In Dimensions

    ROUGH-IN DIMENSIONS 安装尺寸 72866T-CP Strayt Sensor Faucet - Cold Only (AC w/o power unit) 斯磊台盆感应龙头-交流电 (单冷型不含交流电源盒) 16305T-NA Whole metope AC/DC transformer Vessel rim G1/2 Please prepare external thread angle valve G1/2 Output: DC6V Input: AC220V 220V 直流电压6V 72867T-CP Strayt Sensor Faucet - Cold Only (DC) 斯磊台盆感应龙头-直流电(单冷型)...
  • Page 4: Technical Specification

    TECHNICAL SPECIFICATION 技术参数 Power: DC 4 pieces of AA size alkaline batteries (LR06x4) 电源:直流 4节5号碱性电池(LR06×4) AC 220V, frequency 50/60Hz 交流 电压220V,频率50/60Hz Inspection Duration: ≤ 0.5s 检测时间:小于0.5秒 Shut-off Delay: 0.5~1s 关阀延时:0.5~1秒 Sensing Distance: auto adjust 感应距离:自动调节 Flow Rate: No more than 2.0L/min at 0.3MPa. 流量:水压为0.3MPa 时,流量不大于...
  • Page 5 2. Fasten control valve assembly 控制阀组件的安装固定 Unscrew valve cover screws (12) with a 用螺丝刀拧下阀盒盖螺钉(12),将 screwdriver and open valve cover (11). 阀盒盖(11)打开。根据安装尺寸图 Determine control box assembly (10) 确定控制阀组件(10)安装位置,打 installation location per rough-in; then drill holes, and punch plastic expansion 孔,打入膨胀管(13),使阀盒紧贴 tube (13) in. Place valve box against the 墙面且控制阀组件出水口朝上,再...
  • Page 6 Finally, connect red-green wires on 最后,将电磁阀上的红绿线与对应阀 solenoid valve with corresponding 盒盖组件上的红绿线接插,将电池盒 red-green wire on valve cover assembly; connect black-orange wire 或交流电源盒上黑橙线与主控板组 on battery box or AC power transformer with black-orange wire on 件上黑橙线接插,(交流版请将主 main control board assembly. (For AC: 控板组件上的黑橙线从小U型缺口 please lead black-orange wire from small “U”...
  • Page 7 HOW TO INSTALL THE AC/DC 如何安装交流电源盒 TRANSFORMER (Only used for (仅限于交流电感应龙头, AC sensor faucet. Customers 若用户另购交流电源盒,具 purchasing AC transformer can 体安装详见其说明书) refer to the installations instruction.) 一个交流电源盒供一个感应龙头 Wire connection pattern for one-to-one 感应龙头 Faucet 台盆顶面 Vessel rim 用户自备角阀 G1/2外螺纹 Please prepare external thread angle valve G1/2 交流电源盒...
  • Page 8 1. AC power unit (sticker on the back) should be installed 1.电源盒 (背面有不干胶)应安装在干燥,不会被水 in a dry place away from water. Customers should prepare 淋湿、浸泡的位置。根据需要客户自备穿线管及 wire tube and wire according to their requirements. Wire 连接线。穿线管安装在墙内。建议交流电源线采用 tube should be mounted into the wall. Suggested wire:AC 带绝缘和护套层的电线,导体标称截面积...
  • Page 9 HOW TO CHANGE TO A THERMOSTATIC 如何转换成恒温阀感应龙头 SENSOR FAUCET (If customer purchased (若用户另购恒温阀16294T-3-CP, the thermostatic valve 16294T-3-CP, please 具体安装详见其说明书) refer to the installation manual) 接感应龙头 Connect Sensor Faucet 用户自备角阀 外螺纹 用户自备角阀 外螺纹 Please prepare external Please prepare external thread angle valve G1/2 thread angle valve G1/2 墙面...
  • Page 10: Installation Checklist

    许多清洁剂,比如氨水,去污粉及洁厕灵等,会 chlorine, toilet cleaner etc. which could adversely affect the 对电镀表面造成伤害,切忌使用。 finish and are not recommended for cleaning. 有腐蚀性的清洁剂或溶剂不可使用于科勒的水龙 Do not use abrasive cleaners or solvents on Kohler faucets and fittings. 头及其配件上。 IMPORTANT CONSUMER INFORMATION 用户须知 1. Light Indictor Key 1.
  • Page 11: Troubleshooting

    1 minute without switching off (indicator does not flash) Please contact with distributor or Kohler China Investment Co., Ltd., if the trouble remains after above-mentioned actions are taken.Please do not disassemble the other parts of the faucet freely except installing and replacing batteries.
  • Page 12: Service Parts

    斯磊 STRAYT SERVICE PARTS 零 件 图 1226412-SP-CP Cover 1035611-SP-CP 后盖 Drain 1226410-SP-CP Plug 2.5mm Hex Wrench Spout Body 色扣 2.5mm 壳体 Screw 螺钉 Screw 螺钉 1228010-SP Assembly Sensor Inlet,Cylinder 16305T-NA 探头组件 进水接头 AC/DC Transformer 1211203-SP 1068120-SP 1226413-SP-CP (Only for 72866T-CP) Aerator Deckplate Connection Wire Kit...
  • Page 13 产品中有害物质含量的说明 回收提示 本产品超过使用期限或经过维修无法正常使用后,不应随意丢弃,请交由有废弃电器电子产品处理资质的 企业处理,正确的处理方法请查阅国家或当地有关废旧电器电子产品处理的规定。 有害物质统计表 有害物质名称 部件名称 六价铬 多溴二苯醚 多溴联苯 铅(Pb) 镉(Cd) 汞(Hg) (Cr(VI)) (PBDE) (PBB) × ○ ○ ○ ○ ○ 外壳组件 ○ ○ ○ ○ × ○ 阀体组件 ○ × ○ ○ ○ ○ 控制盒组件 ○ ○ ○ ○...
  • Page 14 :Indicate only partial product series contains this substance. Note: the information provided is based on the supplier data and Kohler inspection results. The product is designed not to hurt the environment. Under current technology, all hazardous materials have been used in the smallest amounts possible. Kohler will strive to reduce the use of these hazardous materials used in this product.

This manual is also suitable for:

Strayt k-72867t-cp