Advertisement
Quick Links
EHWJS100
Portable Hot Wire Foam Cutter
Please read these instructions carefully before operation.
Take note of the safety prompts in these instructions to avoid injury to yourself, other people and objects.
Please follow the guidelines in these instructions to avoid damage to the tool.
Caution: Use outdoors or in a well-ventilated space
NOTE: The Power Switch is designed to be manually activated before and throughout the cutting process
for each cut. It should never be placed in a fixed "ON" position using tape, wire ties or other devices.
DO NOT TOUCH HOT WIRE WHEN WORKING!!
TapeTech Tools
1327 Northbrook Parkway, Suite 400
1-844-TT-TOOLS
www.tapetech.com
Suwanee, GA 30024
Advertisement
Related Manuals for TapeTech EHWJS100
Summary of Contents for TapeTech EHWJS100
- Page 1 EHWJS100 Portable Hot Wire Foam Cutter Please read these instructions carefully before operation. Take note of the safety prompts in these instructions to avoid injury to yourself, other people and objects. Please follow the guidelines in these instructions to avoid damage to the tool.
- Page 2 EHWJS100 Key Components Miter Adjustment Knob (upper) Upper Slide Assembly Limiter Blocks Main Panel Support Arms - Left Support Arms - Right Power Switch (on back of Bow) Ruler Support Panel - Left Support Panel - Right Power Supply Module...
- Page 3 Set Up 2. Set Rear Leg Assembly 1. Attach Front Legs to back of Main Panel 3. Attach Power Module to front of 4. Adjust Side Support Arms 5. Loosen Miter Adjustment Knobs Bow with M6 screws (provided) and Rotate Bow into position 6.
-
Page 4: Recommended Use
(XPS) foam. Installation of the Hot Wire WARNING: Always unplug the power cord of the EHWJS100 before installing or changing the hot wire. Allow sufficient cooling time for the hot wire and the springs. It is recommended to use only TapeTech replacement hot Simultaneously…... - Page 5 Cutting Grooves The EHWJS100 can quickly and cleanly cut square-edged grooves in the face or the edge of EPS or XPS foam panels. To cut grooves, you will need to use the Limiter Blocks located on the Upper and Lower Slide Assemblies.
-
Page 6: Technical Data
WARNING: Before servicing and changing hot wire, disconnect tools from the power supply. To prevent damage to the tool it is recommended to use only authentic TapeTech replacement hot wires for the EHWJS100. Part #: EHW100 Please use only qualified service technicians to service or repair the tool. -
Page 7: Spare Parts List
Spare parts list: 1. Upper sliding rail corner component 14. Front leg 2. Upper sliding rail 15. Rear brace assembly 3. Bow 16. Support panel assembly (L) 4. Power Switch 17. Material support rail 5. M6 screw 18. Switch limit dial indicator 6.
Need help?
Do you have a question about the EHWJS100 and is the answer not in the manual?
Questions and answers