Diagnostics Tab - SMC Networks HPAV-ETH Manual

"Set Local Device Only" button
The "Set Local Device Only" button is used to change the network name of the local
device only. After changing the network name to a new one, all the devices existing in
the same network before will no longer be able to communicate or respond to you
because they will not have the same network name within the local device.
"Set All Devices" button
The "Set All Devices" button is used to change the network name of all devices in the
logical networks, both local and remote, that are shown in the Main Tab. Please enter
the password for remote devices in advance, following the instructions in "Enter
Password" button to ensure that this function can proceed normally.

3.4.3 Diagnostics Tab

The "Diagnostics" tab shows the system information and the history of all devices that
have been found before in the logical network (Figure 6).
The upper window of the Diagnostics tab shows the host computer's system
information:
MAC Address of all NICs (network interface card)
MAC Address and the firmware version of the SMCHPAV-ETH device which is
connected to each NIC.
Computer name
User name
Processor and operating system information
Utility version
Versions of all the driver DLLs and libraries used
17