Fcc Requirement - PROLiNK Pixelview MVGA-NVTNT2A User Manual

FCC Requirement

This device has been certified to comply with the limits for a Class B computing device pursuant to
Subpart. J of Part 15 of the FCC Rules. See instructions if interference to radio reception is suspected.
WARNING:
This equipment generates and uses radio frequency energy and, if not installed and
used properly, that is, in strict accordance with the manufacturer's instructions, may
cause interference to radio or television reception.
It has been tested and found to comply with the limits for a Class B compliant device in accordance
with the specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference in a residential installation.
However, there is no guarantee that interference-will not occur in a particular installation.
If this equipment does cause interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
˙ Reorient the receiving antenna
˙ Relocate the computer away from the receiver
˙ Move the computer away from the receiver
˙ Plug the computer into a different outlet so that the computer and the receiver are on
different branch circuits
˙ Ensure that the card's mounting screws, attachment connector screws, and ground wires
are tightly secured
˙ Ensure that slot covers are installed in all unused slots
If necessary, consult your dealer, service representative, or an experienced radio/television technician
for additional suggestions.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. It is the responsibility of the user to correct such interference.
The user may find the following booklet prepared by the Federal Communications Commission helpful:
How to Identify and Resolve Radio-TV Interference Problems.
This booklet is available from the Government Printing Office, Washington, D.C. 20402, Stock No.
004-000345-4.
You must use shielded interface cables with a ferrite bead in order to maintain compliance
NOTE:
with the limits for a Class B device.
CAUTION:
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT
II