Voice Recording - TTS Bee-Bot User Manual

Bee-Bot's Lights and Sound
The table below shows the light and sound effects that Bee-Bot makes when used:
Action
When a command button is pressed.
When a command is performed by
Bee-Bot.
When a set of commands are
performed and completed by Bee-Bot.
Top Tips for Using Bee-Bot
• Ensure a Flat Surface
Make sure the surface you are using is flat and free of raised areas. Uneven surfaces can
hinder the movement of the Bee-Bot.
• Check the Wheels
Inspect Bee-Bot's wheels for any debris. Foreign objects can interfere with its movement.
• Delete Previous Commands
After Bee-Bot has completed a set of commands, it is essential to press the delete button
(blue X button), before inputting a new set of commands. If this step is overlooked, Bee-
Bot will carry out all the commands stored in its memory, which may result in it moving in
an undesired direction.

Voice Recording

To record and listen to audio, follow these simple steps:
1. Choose the button
Select the button on Bee-Bot that you want to record audio for.
2. Start Recording
Press and hold the button for 2 seconds until you hear a single beep.
3. Record Your Audio
Speak or make a sound close to the Bee-Bot before the double beep sounds.
4. End of Recording
The recording time has ended once you hear the double beep.
5. Playback
When you press the button, the audio recording will replace the usual beep sound.
6. Repeat
To record audio on any other button, repeat the above steps.
Light and Sound Effect
Bee-Bot flashes its eyes once and makes a short beep
sound.
Bee-Bot flashes its eyes once and makes a short beep
sound.
Bee-Bot flashes its eyes three times and makes three
longer beep sounds.