Pro-Ject Audio Systems Power Box RS2 Amp Instructions For Use page 3

PWR OUT
To achieve the maximum performance of Amp Box RS2 we offer two power output voltages:
- Use 45V for 8 ohms speakers
- Use 35V for 4 ohms speakers
Technical specifications Pro-Ject Power Box RS2 Amp
Input Power supply:
Output voltage - switchable:
Output current:
Dimension (W x D x H):
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit
be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Should a problem be encountered which cannot be identified or resolved, please contact point of
purchase/dealer for further advice. Only if the problem cannot be resolved there, the unit should be
sent to the responsible distributor in your country. Warranty is valid in country of purchase and for
original purchaser only and is not internationally nor personally transferable.
Copyright, trademarks
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright 2024. All rights reserved.
©
115V/230V AC
±35 V / ±45 V
4A
206 x 209 x 71
4700 g
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Pro-Ject Audio Systems · Power Box RS2 Amp · Revision 2024.09.06
3