Troubleshooting; Trouble; Possible Cause; Suggested Action - Power Tech Generators PTK-15-20Si Operator's Manual

TROUBLE

Generator will not start via
remote panel or other source
Engine does not crank from
local controller
Engine cranks but doesn't start
Engine Starts but shuts down
after a few seconds
Engine Starts but genset not
producing Voltage
For all other trouble shooting issues please contact one of our dealers on our website.
www.powertechgenrators.com

TROUBLESHOOTING

POSSIBLE CAUSE

Generator is not in "auto" mode
Remote connection plug is not
connected
Battery is low or terminals are
dirty.
Crank circuitry wiring improperly
connected.
Out of fuel.
Fuel relay damaged
Fuel System lost prime
See failure on controller LCD
Display
Main breaker is in the "off"
position
Visually inspect all Generator
Output leads for connectivity
or scan the QR code below.
PTK-15-20Si Operators Manual
Generating Power to the World

SUGGESTED ACTION

Put Generator in Auto mode via
controller
Reconnect Remote control Plug
Clean terminals and re-charge
battery.
Replace battery if necessary.
Refer to engine control wiring and
check crank connections.
Check fuel level, add fuel if
necessary.
Check fuel relay and replace if
damaged.
Use Primer on top of fuel filter
Turn Main Breaker to the "on"
position
.
Page 26 of 26