VDO MS 4200 RS Owner's Manual page 18

INSTALLATION INSTRUCTIONS
Loudspeaker test
To check the correct connection of the loudspeakers, perform the "
" function in the "INITIALISATION" menu.
Setting the time zone and time format
Set the desired time format (12 or 24-hour) and the time zone for your location under
" " in the "INITIALISATION" menu.
Checking the vehicle functions
A
Check the safety-relevant vehicle functions only when the vehicle is stationary, or
moving at low speed. Only perform the check in an open area.
Brake system, alarm system, lights, immobiliser, speedometer, trip computer, clock.
Checking GPS reception and calibrating the system
Enter a destination and select "
menu via the guidance screen (see operating instructions) and check the number of
satellites. For a sufficiently exact location determination, the number should be
between 4 and 8.
As soon as adequate GPS reception is available, perform a short test drive (approx. 10
minutes) on digitised roads in order to calibrate the system. Calibration takes place
fully automatically. Turn off several times and drive through a number of junctions.
Then check whether the navigation system indicates the correct vehicle position in the
" " information menu.
Note: The system can also be calibrated without C-IQ contents activated. However, no
directional information will be provided. The current vehicle position can then be
checked in the emergency menu (see operating instructions).
Removing the radio, Fig. 14
The radio can be released using the pair of U-shaped removal tools supplied.
Push both U-shaped tools into the small holes to the right and left of the unit front
until they are felt to engage.
Gently push the tools outwards and carefully pull the radio out of the installation
bracket using the tools.
Service
Please visit our website for up-to-date information:
www.vdodayton.com
or contact a VDO Dayton dealer.
Subject to technical modifications and errors.
16
". Call up the " " information