VDO MS 4100 User Manual page 12

Setting the mounting angle
In order to ensure perfect functioning of the system, the navigation radio must be set
to the actual installation angle in the instrument panel. The angle scale on the inner
cover can be used to determine the mounting angle in degrees.
1. In navigation mode:
Select the option "
2. Depending upon the installation, set the angle to between -10 and +30 degrees. The
system does not differentiate between negative and positive angles. Thus, even for a
mounting angle of, e.g. -10 degrees, set a value of "10" in the menu.
Loudspeaker test
To check the correct connection of the loudspeakers the function "
in the "INITIALISATION" menu can be performed.
Setting the clock and the time zone
To ensure that the correct time is always displayed, select the option "
"INITIALISATION" menu under "
location. Page 39.
Checking the vehicle functions
A
Check the safety-relevant vehicle functions only when the car is stationary or at
moving at low speed. Only perform check in an open area.
Brake system, alarm system, lights, immobiliser, speedometer, on-board computer, clock.
Checking GPS reception
Enter a destination and select "
check the number of satellites. For a sufficiently exact location determination the
number should be between 4 and 8.
Calibrating the system
For automatic calibration, perform a short test drive (approx. 10 minutes) on digitised
roads. Change direction several times.
Drive through several intersections and monitor the current vehicle position on info
screen i1 "
position, calibration is complete.
Hotline
Hotlines are available in many countries to handle queries about the VDO Dayton
multimedia systems:
G
0121 344 5400
Q
1 800 335 282 Toll Free or (03) 94503166
Subject to technical modifications and errors.
" in the "
". Call up info screen i3, "
". Once the displayed position agrees with the actual car
INSTALLATION INSTRUCTIONS
" menu.
Page 39.
" and set the time zone for your
"
" in the
", and
13