Do you have a question about the T612 and is the answer not in the manual?
Questions and answers
Mo Wright
March 11, 2025
How do I change the battery
1 comments:
Mr. Anderson
March 11, 2025
To change the battery in the Altec Lansing T612 remote, follow these steps:
1. Locate the battery compartment on the back of the remote. 2. Open the compartment to access the battery. 3. Remove the old battery. 4. Insert a new battery, ensuring the correct polarity. 5. Close the battery compartment securely.
Altec Lansing ships the remote battery separately to prevent power drain, so you will need to install it before first use.
This answer is automatically generated
Hans Metten
February 26, 2025
My T612 will play my iPod but will not power it. On a full charge the iPod runs for two minutes on a song and then gives a message "connect to power". It always worked but when I turned it on after year of sitting idle it now won't send power to the iPod. Please advise if you can repair it.
1 comments:
Mr. Anderson
February 26, 2025
The Altec Lansing T612 is designed to provide power and audio support to compatible iPods through its docking station. However, whether it can be repaired to restore power functionality depends on the specific issue. If the problem is with the power adapter, a compatible replacement adapter (such as the LKPower AC/DC adapter) may resolve it. If the issue is internal, such as a damaged circuit or connector, professional repair may be required.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s What Will Altec Lansing Do To Correct The Problem?: Altec Lansing will, at its option, repair or instructions. The apparatus should not be situated on a bed, sofa, rug or similar surface replace any product that proves to be defective in material or workmanship.
• Seat your iPhone by sliding your iPhone on top of the T612 docking use “Flight Mode” while you listen to music. Instead, keep the phone station. turned on; when a call comes in the T612 gives priority to the call by interrupting the music. Connecting your iPod...
“+” button to increase the corresponding level, or the “–” button to decrease it. Song Functions When an iPhone or iPod is docked into the T612 and the T612 is turned on, some song functions can be controlled using the T612’s remote control.
Plug another device into the same wall outlet to confirm the outlet is working. The power isn’t turned on. Turn on the T612 by pushing the power button located on the top of the unit. A LED will light when the power is on. No sound is coming The volume is set too low.
Need help?
Do you have a question about the T612 and is the answer not in the manual?
Questions and answers
How do I change the battery
To change the battery in the Altec Lansing T612 remote, follow these steps:
1. Locate the battery compartment on the back of the remote.
2. Open the compartment to access the battery.
3. Remove the old battery.
4. Insert a new battery, ensuring the correct polarity.
5. Close the battery compartment securely.
Altec Lansing ships the remote battery separately to prevent power drain, so you will need to install it before first use.
This answer is automatically generated
My T612 will play my iPod but will not power it. On a full charge the iPod runs for two minutes on a song and then gives a message "connect to power". It always worked but when I turned it on after year of sitting idle it now won't send power to the iPod. Please advise if you can repair it.
The Altec Lansing T612 is designed to provide power and audio support to compatible iPods through its docking station. However, whether it can be repaired to restore power functionality depends on the specific issue. If the problem is with the power adapter, a compatible replacement adapter (such as the LKPower AC/DC adapter) may resolve it. If the issue is internal, such as a damaged circuit or connector, professional repair may be required.
This answer is automatically generated