IMPORTANT SAFEGUARDS
Basic safety precautions should always be followed, including:
READ ALL THE INSTRUCTIONS
1. Use the chefiqlo Sense™ for its intended purpose only.
For use with food only.
2. CAUTION: The probe gets HOT! Do not touch the probe
with bare hands during or after cooking.
3. To reduce the risk of electrical shock, do not submerge the
hub in water or other liquids.
4. To avoid damage to the probe, insert it in the food to
the minimum insertion point marked on the probe. The
internal components have a max temperature of 212°F.
Temperatures above that can damage the probe. When
cooking, ensure that the exposed end of the probe does
not touch hot cooking surfaces.
5. Do not use the thermometer when microwaving
or pressure cooking.
6. After using, let the probe cool, then clean as directed. Dry
completely before storing.
7. Do not drop the probe(s) on a hard surface.
8. Though the probe is top-rack dishwasher safe, it's better to hand
wash it. Use warm, soapy water, and rinse and dry it well. Do not
use scouring pads or abrasive cleaners, which will scratch it.
9. The chefiqlo Sense probe is waterproof. However, avoid
drastic changes in temperature; for example, do not
plunge it in ice water when hot.
10. Store the probe(s) in the charging nest(s) of the Smart Hub.
Be sure they are completely dry before storing.
11. The probe is SHARP! Care should be exercised when handling
the probe. This appliance should not be used by or near children
or individuals with certain disabilities.
12. Take care when inserting and removing the probe. Do not apply
excessive pressure and avoid extreme changes in direction.
13. Consuming undercooked meats, poultry, or seafood may
increase the risk of foodborne illness. To avoid this risk, cook
your food to the temperatures recommended by the USDA.
14. Follow local regulations when recycling.
CALIFORNIA PROPOSITION 65:
(Applicable to California residents only.)
WARNING: Cancer and Reproductive Harm –
www.P65Warnings.ca.gov.
HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
6
Need help?
Do you have a question about the iQ Sense CHEF PROBE-V3 and is the answer not in the manual?
Questions and answers
we have the 3 probe set. tried using 2 probes but only one is being recognized
The document does not provide specific troubleshooting steps for this issue. However, possible reasons could include improper pairing, low battery, or a defective probe. Ensure all probes are charged, correctly inserted, and properly connected to the app. If the issue persists, contacting support may be necessary.
This answer is automatically generated